Skip the auto shop - Our mechanics make house calls

Q: Replace all ball joints and tie rods

asked by on

How much labor would it cost to replace all four ball joints and tie rod ends on a 2006 Dodge 1500 2 wheel drive 4.7 v8

My car has 160000 miles.
My car has an automatic transmission.

Billing question sent to CS for the cost of labor to replace all four ball joints and the tie rod ends on a 2006 Dodge Ram 1500 with a V8-4.7L engine.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Front wheel is making a creaking noise

A creaking noise is going to be most likely a lower ball joint or lower control arm bushings. The noise is due to lack of lubrication and may be in the front wheel bearing also. Have the vehicle inspected by...

Q: Turn selector switch to 2 Wheel Dr. and it stays in four-wheel-drive and then yellow light comes on on the dash and says service

Hello, thank you for writing in. The vehicle is equipped with an electric transfer case, in which something has gone wrong. The fact your are stuck in 4WD, is because the computers programming demands the system shuts down during this...

Q: Steering Wheel Locked, Leaking Power Steering Fluid

If your steering is not working properly, I believe it would be due to the major power steering fluid leak. In order to resolve this issue the power steering fluid system must be functioning properly. Once this has been done,...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.