Q: P0230 fuel pump primary circuit code

If the lights are fully illuminated, the starter or it's circuit is the most likely cause of your problem. However, an internal engine problem or problems with the battery could also be the cause. A trained technician will be able...

A misfire can be caused by a lot of things, from a worn spark plug to an internal engine problem. The first step is to retrieve the diagnostic codes associated with the check engine light. These codes will provide a...

I would try to have the idle air control valve cleaned (https://www.yourmechanic.com/article/how-to-clean-an-idle-air-control-valve-by-joyce-morse) first. Then if that does not work then have it replaced. You may save some money. Whether you decide to clean it or replace it, have the throttle...

Hello. If the oil level was low, then it will cause these codes (P0016 (https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) and P0017 (https://www.yourmechanic.com/article/p0079-obd-ii-trouble-code-crankshaft-position-camshaft-position-correlation-bank-1-sensor-b-by-jay-safford)) to appear. The variable valve timing system on this vehicle is controlled with oil pressure so when the oil level is low...

Hi there. The ETC (electronic throttle control)/transmission) light coming on, put the vehicle in limp home mode. This would feel like the vehicle has lost power. The APP (accelerator pedal position) may be at fault (https://www.yourmechanic.com/services/electrical-components-are-not-working-inspection). The ETC/throttle body (https://www.yourmechanic.com/services/throttle-body-replacement)...

The full body kit is designed for the RX-7 from 1993 to 2002 models. Your model of the R2 and the kits model of FD3S is the same design only a little different to accommodate for an engine with dual...

Check for a resistance from the relay to the ignition switch with the key on and the relay removed. If the ohm meter reads OL, then the circuit has a break in it and it needs repaired. If the meter...

5W-30 is perfectly OK to use on this vehicle on a temporary basis. The only detriment, and it will be hard to detect without complex measuring equipment, is the higher viscosity 5W-30 technically creates "pumping losses" in the engine which...