Q: One of my fuel injector burned out what's wrong?

asked by on

My fuel injector burned out what's wrong?

My car has 256344 miles.
My car has an automatic transmission.

If you are referring to the electrical solenoid within the injector, like any electrical part it can fail due to degradation of the insulation, wire breaks and so forth. The injector can be tested while still on the car and if indeed it has failed you can request fuel injector replacement and the responding certified mechanic will make all necessary repairs. If one injector is replaced, for best results in terms of cylinder balancing, the other three injectors should be removed from the fuel rail and sent a lab such as Mr. Injector for cleaning, replacement of the tiny internal filter baskets, and verification. Serving all the injectors and replacing the internal injector filters at the same time will promote a smooth running, more efficient engine and that helps to avoid future problems. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. One of my fuel injector burned out what's wrong?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: When I put gas in, after a few seconds it spits it back out.

Hi there. The fuel vent hose on the fuel filler neck is plugged and not allowing the fuel to vent as the tank is filled up. You may have to remove the rubber hose to the tank and take a...

Q: Do I need to replace the turbo?

Hello. There are several reasons why your car might be low on power. Some of these are related to the turbocharging system: lose high pressure hoses, blow-off valve control hoses, and circuitry (regulates the amount of boost to the engine...

Q: where is crankshaft sensor located on a 2000 protege

The crankshaft sensor is on the front of engine below and behind the crankshaft pulley. The air gap on the new sensor should be set to .020 to .060. If gap is too big it will not start and if...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...