Skip the auto shop - Our mechanics make house calls

Q: O2 sensor

asked by on

I was replacing my o2 sensor that is on the manifold and the bung came off.. Do I have to weld it back on or is there another way of doing it
My car has an automatic transmission.

You may have to get the manifold repaired- if it can be welded on an O2 adapter nut. If not then replacing the bad manifold or pipe will be needed.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I have an 05 Liberty CRD. It is stalling out at idle or when pulling up to a red light. This very random.

Hello there, thank you for asking about your 2005 Jeep Liberty. This is typically a common symptom of a failing idle air control valve, which is a unit that monitors the air intake as it is mixed with the fuel...

Q: Where do I find the emissions control label?

The emissions control label gives you important information about the emissions system in the car, and what regulations it meets. This information may be necessary during emissions testing. You’ll find the label on the underside of the hood, on the...

Q: How do you set up Bluetooth connectivity?

The Bluetooth system in your car allows you to make calls without having to use the phone, which enhances safety while on the road. Of course, you have to set the system up first. Here’s how: Turn the ignition...

Related articles

How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.