Q: Knocking after turning left seems to go away when straightening up 2004 Peugeot 407
when turning left from stand still heard a knocking noise from front of car (peugeot 407 04yr) next junction listend (was right turn) could not hear anything, next slow speed left turn heard what sounded like a knocking ( like when a bearing goes) since, i have made sure the sound is coming from the steering. I have to drive for a few miles on a motorway to work and am concerned if it could be dangerous could you give your advise please
My car has 112000 miles.
My car has a manual transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Gauges and Radio flicker when driving
This could be caused by a faulty power steering cooling fan. The Mini's have an electrically controlled fan that will de-activate power assist if the fluid temperature exceeds a programmed standard to prevent damage to the power steering system. These...
Car stalling
Hello there. A few different malfunctions could cause this: Fuel pump failure (https://www.yourmechanic.com/services/fuel-pump-replacement) Alternator fuse failure (https://www.yourmechanic.com/services/fuse-replacement) Ignition switch failure (https://www.yourmechanic.com/services/ignition-switch-replacement) Any of these items could cause the fault. A qualified technician such as the ones at YourMechanic will be...
Putting new engine in a '88 Pontiac Firebird Formula
If it's an '88, it will have an orifice tube. They have always had orifice tubes. Most of the orifice tubes on GM products come off of the condenser in the front of a vehicle. The hose that comes out...
Change check transmission fluid
Hello there. The Nissan Versa and many newer vehicles do not come equipped with transmission dipsticks. The owner's manual (which comes with the car) should have details for how the CVT transmission fluid is checked, as this is a service...
I am thinking of buying a 98 Lexus LS400 with 200,000 mi for $3000. IT runs great and is in beautiful condition. Check Engine light is on 1998 Lexus LS400
Hello - as to the starter question, if the starter starts to spin immediately after you turn the key to the "Start" position, spins the motor over briskly without strange noises, hot or cold - the starter is probably fine....
Replaced master/slave cylinder and clutch pedal is hard as a rock and won't depress what could it be?
You need to open the bleeder on the slave cylinder to see if the clutch can be pressed down? If it still cannot be pushed down then the problem is in the clutch master cylinder and it is binding. If...
where is the bank 2 sensor 1 located on a 2010 ford f-150
When it comes to a Ford, cylinder #1 is on the passenger side of the vehicle, so that makes the passenger side Bank 1. Bank 2 is the driver's side of the engine. Sensor 1 is the sensor in front...
Cylinder 3 misfire
The "suspect" coil should have been tested prior to replacement; there might not have been anything wrong with it or the terminals might simply have needed to be cleaned (sometimes the terminals will get rusty or corroded). The other coils...
Heat and AC fan not working on 2007 chevy Cobalt.
You should first check the fuse labeled BCM 3 in the engine fuse box and then if it is good then check blower motor for power when system is on? If blower has power but does not turn then try...
Related articles
Is it Safe to Drive With a Bad Axle?
The axles transmit power from either the transmission or the differential to the drive wheels on your car. If one of your...
Is It Safe to Drive With a Bent Axle?
Your car’s axles are essential components. They transmit power from the transmission or differential to the drive wheels. While they’re designed to be...
Is It Safe to Drive With a Damaged CV Joint?
In a front-wheel drive car, the axles are connected to the wheels with Constant Velocity (CV) joints. These allow the axle and...
Browse other content
Estimates
Maintenance