Q: No start after crankshaft position sensor replacement
I put a new cps sensor in and it won't start put the old cps sensor back in and it start what do I do?
My car has 88000 miles.
My car has a manual transmission.
Recommended Services
| Car is not starting Inspection | $94.99 - $114.99 | Get a Quote |
I would recommend putting the old sensor back in and continuing to drive it. If there are no Check Engine Lights on and it performs as it should, you should not have any problems. If you installed by recommendation of a check engine code, I would suggest revisiting the code to see what other possibilities may cause the no-start issue as they are often times linked to multiple possibilities.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Advice on how to find the exhaust manifold leak
The first thing to do is check it when the engine is cold. When it is cold the metal shrinks and if it is leaking, it will leak more. Also, since it's cold you can feel around with your hands....
SUV hesitates when driving slowly and accelerating
If you have water in the gas, then you will have problems with the way it runs. I recommend having a fuel sample tested to see if you have water in the fuel. If you have an aftermarket air filter...
Engine light on, black smoke coming out exhaust on acceleration and fault codes
The glow plug faults are most likely going to cause a hard start condition, which will be most noticeable when the engine is cold. The colder the engine, the more difficult it would be to start usually. Often times, glow...
where is the ecm control modu
The ECM is located behind the left front wheel well cover splash cover.
Po155cnf bank 2 sensor heater circuit P1620cnf Also code
The P0155 (https://www.yourmechanic.com/article/p0155-obd-ii-trouble-code-02-sensor-heater-circuit-malfunction-bank-2-sensor-1-by-jamahl-walker) is the oxygen sensor located on the rear bank of cylinders and before the catalytic converter. Given your mileage, both oxygen sensors (https://www.yourmechanic.com/services/oxygen-sensor-replacement) (pre-catalytic converter) should be replaced. The pre-cat sensors have the most affect on fuel...
I put a penny in place of a fuse, tried to start my car and now it wont start and makes a grinding sound when i try to start it
Hi there. Putting a penny in place of a fuse, not recommended, replace with the correct fuse (https://www.yourmechanic.com/services/fuse-replacement). The fuse is there, to protect the circuit. If the fuse blows (https://www.yourmechanic.com/services/electric-problems-inspection), there is a short to ground. The grinding sound,...
Stalling while driving
Hi Jacob: Sometimes spending a few dollars to have a professional mobile mechanic complete a car is hard to start inspection is the best way to properly diagnose why a vehicle is having issues like you've described. However, it's very...
The battery is dead and wont jump
Hi there. More likely than not, the problem you are describing is not caused by a dead battery; but instead, bad battery cables. However, it is possible for a battery to drain to the point where attempting to jump start...
Car starts n idles fine. When I put it in gear it stalls. I'm thinking transmission fluid problems? Also it "CLANKS" when shifting
The torque converter and torque converter lock up solenoid should be evaluated. Another possibility is an internal hydraulic leak in transmission seals causing pressure to apply both reverse and forward gears at the same time, lock up the transmission and...
Related articles
Symptoms of a Bad or Failing EGR Temperature Sensor
Common signs include engine ping or knock, the Check Engine Light coming on, and failing an emissions test.
How Long Does an Air Charge Temperature Sensor Last?
The The air charge temperature sensor, also referred to as the intake air temperature sensor, works to monitor the temperature of the air as it enters your car engine. The engine’s computer has to have this information so it can...
How to Replace a Car Battery Temperature Sensor
The battery has a battery temperature sensor that can fail if the Check Engine Light comes on, the battery voltage is low, or the RPM curve surges.
Browse other content
Estimates
Cities