Q: Need someone to help me get my car started.

This code is for evaporative emissions (EVAP) purge system performance. The EVAP system is responsible for preventing fuel vapor emission from entering the atmosphere. The EVAP system uses a purge valve to allow stored fuel vapors from the fuel tank...

Unfortunately, the repair information I have for this vehicle and code are rather sparse. Doing a little research, I found this code stands for "Charge Air Cooler Efficiency Below Threshold." The most common cause of this code does appear to...

Hello. There could be a problem with the throttle cable sticking, causing the high idle. There also could be a problem with the throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) malfunctioning, causing a high idle. Sometimes a dirty throttle body (https://www.yourmechanic.com/services/clean-throttle-body) can cause...

Hello - there are several problems which could cause the behavior you mention. A failed throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) can cause the high idle, and poor shift/no shift behavior you describe since the engine & transmission communicate with each other...

Hi there. The shift rail fork on the shifter is bent. Remove the rubber boot to the shifter and remove the bolts to the shifter to take it off of the transmission. Remove the shifter from the transmission. Check the...

Hi there. It sounds like the camera has failed or has lost connection. The cameras for these systems are prone to failing and it does happen often. To check for a loose connection remove the trunk lid cover and inspect...

The heater control valve (https://www.yourmechanic.com/services/heater-control-valve-replacement) may not be opening fully and/or the heater core, beneath and within the dash, may be partially plugged. In both cases, the result would be inadequate heated engine coolant flow through the heater core and...

Hi There, Unfortunately, the flooding or water damage may cause the camshaft position sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) to fail or potentially cause starting or misfiring (https://www.yourmechanic.com/services/engine-is-misfiring-inspection) issues. The camshaft position sensor may have also been damaged or not hooked up properly if...

This one makes me very curious. The car should continue to run whether the gas cap is loose or not. In fact, the car should be able to run with no gas cap at all, but the check engine light...