Q: Need a diagnostic.

asked by on

I need a diagnostic to identify a problem with my vehicle. How much does that cost?

Most shops charge an hour of labor for a diagnostic. The price for this hour of labor can range anywhere from $90.00 up to $120.00. If you have your diagnostic performed by a technician from YourMechanic you can get this service for $70.00 to $80.00.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Need a diagnostic.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: check engine light with oil leak

Hi John. Thanks for contacting us today. Oil in front of the motor, near the crankshaft pulley, is often from the front crankshaft seal. Although this is not normal, it is common with an engine 20 years old. I'm not...

Q: Coolant leak and squealing noise

The water pump on your engine is a common failure. The seal, or the bearings can squeak when it is going bad. If the bearings have total failure, the water impeller could contact the engine block and make a significant...

Q: 1996 Jeep Grand Cherokee with 180,000 miles. As I'm driving it starts to sputter but still going the speed limit.

Sounds like the crankshaft position sensor is loosing connection when driving. Check the harness to the crankshaft position sensor and see if there is a loose wires or if the contacts can be loose when pushed against. The harness could...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.