Q: My truck won't start but I used a scanner and it says nothing is wrong with it other than the abs so what could be the problem

This is a very dangerous situation as the braking system is one of the most important safety features of a vehicle. Have a brake inspection (https://www.yourmechanic.com/services/brake-safety-inspection-inspection) carried out by a qualified technician such as the ones here at YourMechanic to...

Hi there. A head light replacement sounds like an easy task but can commonly be done incorrectly. If care was not taken by the technician that installed the headlight and the light was handled by the glass part it will...

Hello. It is important when discussing master and slave cylinders to make it clear you are talking about the clutch and not the brake system – there isn't a proportioning valve (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-proportioning-combination-valve) in the clutch system. Both have master cylinders...

It sounds like you may have a dashboard integration unit failure, or a fault within the electrical control unit (ECU) (https://www.yourmechanic.com/article/what-is-a-vehicle-s-electrical-control-unit). It's also possible that the instrument cluster itself is faulty. Have the vehicle scanned for diagnostic trouble codes (DTCs)...

Hey there, thanks for asking about your 2002 Ford Crown Victoria. Burned wires can signify that there has likely been a short somewhere in the electrical system. Often times when this happens, it is quite easy for the car's computer...

It has been my experience that this is normally a sign that a heater core has gone bad. It starts leaking coolant into the heater box, underneath the dash. When the heater is turned on, the air moving through the...

What you are describing sounds like possibly a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, turning on AC or engaging the brakes). The Manifold Absolute Pressure (MAP)...

The manifold line is not normally replaced when compressor or the condenser is replaced unless a problem is noted. In order to replace it now you will need to get a quote from customer service to get estimate for the...

The noise could be due to a worn outer CV joint. This will be particularly likely if the rubber boot (it looks like a bellows) covering the outer CV joint is torn or missing. You can attempt to view the...