Q: My car runs, but it doesnt drive in Drive or reverse.

asked by on

My car turns on, but doesnt drive or reverse. If i push the pedal fills like the engine is giving power but its not moving

My car has 150000 miles.
My car has an automatic transmission.

What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being sent by vehicle speed sensors and engine speed sensors. Based on this information, the Engine Control Unit (ECU), or the Transmission Control Unit (TCM), executes the appropriate upshifts and downshifts by sending a signal to one of several shift solenoids. These transmission solenoids have spring-loaded plungers inside them, which are wrapped with wire. When this coil of wire receives an electrical charge from the TCM / ECU, it causes these plungers to open, allowing transmission fluid to flow into the valve body and pressurize the desired clutches and bands. When this happens, the transmission changes gears and you continue down the road. The computer controls the transmission solenoid in several ways. If the vehicle is equipped with a dedicated Transmission Control Unit, it can open or close the hydraulic circuit using a direct 12v signal. In some cases, the Engine Control Unit (ECU) can control the solenoid’s plunger by turning the ground circuit on and off. When this is not working properly, this can cause a jerking reaction, a delay in shifting or in some cases may cause the transmission to hesitate in shifting gears. I would recommend having a professional from YourMechanic come to your location to diagnose and inspect your transmission.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. My car runs, but it doesnt drive in Drive or reverse.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Automatic won't shift

It sounds like your shifter cable may have come loose. What happens over time the bushing for the the shifter cable that connects to the linkage on the transmission becomes worn and needs replacing because it will not stay connected....

Q: It has a squeezing noise inthe engine area on the passenger side. When I drive, it gets louder. Any suggestions?

Hi there. As you may know, this is most likely related to the power steering in your system, which is electric unlike earlier generations of cars that were hydraulic. This is also a known issue with the 2010 Chevy Malibu...

Q: How long can a car run like when driving back and forth from work when battery saver mode is on? I plan to have it checked after w

The primary function of the battery is to start the vehicle. Once it is running, the alternator provides the electrical needs of the engine, lights,radio,heater,etc. If the alternator is faulty and not producing power, these systems will draw power from...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.