Q: My car is not going forward or backward

You will need a heavy duty set of crimping pliers, a butt connector or terminal, and possibly a short section of wire. I would assume the wire is about 4 gauge in thickness. Take the broken piece to an automotive...

Hello there, unfortunately there is no way to undo deleting the Trip A reset on your 2016 Honda Civic. The vehicle's odometer keeps track of the total milage and cannot be deleted or changed. In most cases the dual trips...

Hi there. The ignition system for the 4.9L in your vehicle, should be HEI (high energy ignition) and does not have a CKP (crankshaft position sensor). The pick-up coil is inside the distributor and most likely is not the cause...

You may have a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. Since...

I looked into the labor time on this online for you. It looks like this job takes about 2.7 hours to do this job. Consider YourMechanic for your water pump replacement (https://www.yourmechanic.com/services/water-pump-replacement) as a certified professional can come to your...

Hello. If your accelerator pedal is no longer working to accelerate your vehicle then it may be possible that your vehicle's throttle cable has snapped. The accelerator pedal is connected to the throttlebody via a steel cable that can sometimes...

The rough running circumstance you are describing is often a consequence of multiple faults in ignition, fuel, and air induction, not to mention the possibility of low or uneven cylinder compression. Just as a for instance, you could have uneven...

Hello - the lack of speedometer and odometer function is most likely caused by a failure of the vehicle speed sensor (or the wiring to it) (https://www.yourmechanic.com/article/how-long-does-a-speed-sensor-last). This sensor, and its wiring, would have to be tested with a voltmeter...

Hello - I suspect you will find blown head gaskets (https://www.yourmechanic.com/question/blown-head-gasket) based on the oil in the coolant" observation, with indications of extremely high pressure coming into the cooling system. Hopefully the determination you have that cylinder heads themselves were...