Skip the auto shop - Our mechanics make house calls

Q: Light bar installation

asked by on

Should I go to a Ford dealership and have them install a about 10 inch light bar onto my car? I would like it placed in the center of the roof.

My car has 1400000 miles.
My car has an automatic transmission.

A: You should not have to go to a dealer to ha...

You should not have to go to a dealer to have the light bar installed. Check around in your area to find a good automotive custom shop or a specified Mustang custom shop. They would be happy to install the light bar for you. Best of luck.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Need to replace the right rear wheel cylinder.

Hi there: If you haven't replaced a brake wheel cylinder before, you might want to do one of two things. First, contact your local Dodge dealership or search online for a service repair manual for your 1989 Dodge Dakota. This...

Q: Heater blows hot for 10 minutes, then it blows cold.

Hello, thanks for writing in. This problem could be either an engine thermostat that is not keeping the engine at a constant running temperature (temp gauge steady in the center), or the heater control valve or controls are malfunctioning not...

Q: what happens if your wheel sounds like you're dragging something while driving

Hey there, thanks for writing in about your 2000 Ford Mustang. It sounds like you have a brake shoe that has come apart and is dragging on the brake drum. Have the rear and front brakes checked to verify and...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.