Q: It won't crank at all. Changed the throttle sensor, pedal accelerator, starter, and ignition switch. what is going on with it? 2001 Chevrolet Suburban 1500

I hate to be the bearer of bad news, but it sounds like your engine is at about the end of its useful life. If a motor seizes, the piston has become so hot and expanded that its stuck in...

Blue smoke coming from the tailpipe is usually an indication that the engine is burning oil (https://www.yourmechanic.com/article/What-Does-It-Mean-When-My-Car-Is-Burning-Oil_3). If the engine is burning oil, the piston rings or valve guide seals may be causing this to happen. The piston rings and...

Yes, corrosion on a ground terminal or splice point can cause various engine and electrical systems issues. Looking at the wiring diagrams I see nothing related between the entertainment and engine control systems that jump out at me as the...

Hi and thanks for contacting YourMechanic. The AdvanceTrac will need to be adjusted for the height difference. As for the rotor being destroyed after putting on the lift, check the caliper to see if the line to it is long...

Hi there. This sounds like the engine timing is off. Check the camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) and crankshaft sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) to see they are working. The computer has the engine in limp mode to keep the rpm's from going up. If...

Hi there. Window tint should be fine in your vehicle. Depending on how the tint was installed, the tint should be ready for use almost immediately. If the tint film was put on with water and a squeegee, then you...

Hello - there are a couple of scenarios which could cause this behavior. If the thermostat fails - sticking shut, or the water pump fails, the engine can overheat very quickly (in seconds) and behave as you describe. A coolant...

If you have had to replace spark plug wires due to melting them then you need to use a stethoscope to check around the burned plug wires to see if there is exhaust leaks from the manifold gaskets and replace...

Hi There, This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, turning on AC or engaging the brakes). The Manifold Absolute Pressure...