Skip the auto shop - Our mechanics make house calls

Q: Issues with MAF sensor and P010B code

asked by on

Hello. My car has MAF sensor issues and the P010B code. I had the MAF cleaned but the issue persists. I had a K&N air filter for years but I had it replaced as the MAF issues appeared while I had that air filter in my car and it was worn out. Now I have the OEM air filter. But, I still have problems with MAF. What should I do?

The vehicle’s Engine Control Module (ECM) may need reprogramming, as to a technical bulletin ITB09-028 dated June 3, 2009. The reprogramming by the dealer will be needed to try and see if the code goes away, if not, further diagnosis will be needed. Your sensor may need to be replaced on Bank 2. Sometimes cleaning them cannot fix all the oil that gets on the sensor from the aftermarket oil filters, which causes shorted sensor wires.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: P2178 and P115D codes are showing up on a scanner. Could both be related to the MAF sensor?

Hi there. The code P115D is for the mass air flow sensor (MAF). It says that the sensor has an offset signal. The code P2178 says that bank 1 is too rich. This means that the engine is running too...

Q: I changed out ignition coil and spark plugs and the car isn't starting anymore. 2008 Infiniti G37

Hello. If the work was done with the correct parts then it should be as simple as something that may have been left loose. If the engine is not cranking over then it may be as simple as a low...

Q: Cyl 4 misfire 07 dakota 3.7l v6, did plugs, coil, injector, inspected lifters no kicked rocker arms, wondering best route of next

I can think of a couple of things that could potentially be causing this issue. If you have an intake manifold gasket leak near the number four cylinder, this can cause the cylinder to misfire. If the number four cylinder's...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
How Much Does a Mechanic Make in Vermont?
Automotive technician jobs in Vermont have an average mechanic salary of $37k, with some mechanics earning a salary of $53k.