Q: i heard yo mu had to replace the wheel hub if the wheel bering damages is tht true

asked by on May 09, 2017

I heard you had to replace the whole wheel hub if the wheel bering breaks

My car has 233000 miles.
My car has an automatic transmission.

If wheel bearing is in need of replacement on this vehicle then you will need to replace the entire hub assembly with it since it comes as an assembly incorporated with the speed sensor.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

What would cause my car to idle hunt..Rev up and down continusly in neutral

Hi There, It sounds like you may have a dirty or failing idle air control valve causing your engine idle to fluctuate and eventually stall. The idle air control valve is a small valve on the engine's intake system that...

Power steering went out completely

Hi there. You might have a blown high pressure hose from the pump to the steering rack. The fluid is getting onto the exhaust system and may pose a fire hazard. I recommend you do not drive the vehicle, for...

My car will not shift out of drive and into park - 1999 Hyundai Sonata

Hi. This sounds like the ignition switch has a problem and is not allowing the car to go into park. If the ignition switch is not sending the signal to the neutral safety switch that the key is in the...

Ran out of gas ('92 Mercedes 500SL) now the car will not start after adding gas

If the car is on level ground, the 2.5 gallons should be enough to cover the fuel pickup. If the car is on a hill, or leaning to one side or the other, it might help to add more gas....

what is an good oil change interval to stick with this car

Toyota recommends changing the engine oil and filter on the 1999 4 cylinder Camry every 12,000 kilometers. Changing the oil, and performing other maintenance, using a mobile service such as YourMechanic, can save you a lot of money. If you...

Noisy lifters

Hi. Noisy lifters can occur for a number of different reasons. The most common being low or old oil or a poor quality oil filter. If the oil filter is restricted or if it is full of debris, then the...

My car revs it's rpms when at park and drives itself to 25 mph without pressure on the gas pedal

This may be a sign of a failing throttle position sensor. The throttle position sensor (TPS) is a sensor used to monitor the throttle position of the throttle plate inside the throttle body in relation to your foot position on...

Mercury Mariner battery light

One hundred forty miles is too far if your alternator has failed, even if you depart with a fully charged battery. In your circumstance, what you want to determine is charging output at the battery posts. Charging output should be...

My brakes are hard when depressed.

Hey there, thanks for writing in. The brake booster has a bad vacuum supply or the booster internal vacuum valve is bad and the booster needs replaced. The complete brake system should be checked and diagnosed by a mechanic to...

Related articles

Is It Unsafe to Continue Driving a Vehicle with Broken Wheel Speed Sensors?
Car wheel speed sensors are an important safety feature. It helps the ABS system work when you need to make an emergency stop.
Symptoms of a Bad or Failing Wheel Hub Assembly
Common signs include a roaring sound from the tires area, vibrating steering wheel, play in the tire/wheel combo, and clicking sound from the wheels.
Symptoms of Bad or Failing Wheel Bearings
Common signs include abnormal tire wear, grinding or roaring noise from the tire area, vibration in the steering wheel, and play in the wheels.