Q: I have proplem in my mazda 6 2008 transmission ihave code p07444

In order for the automatic climate control system to work, it needs to know the temperature inside, as well as the temperature/amount of sunlight entering the cabin. It gets this information from two sensors. Sunlight Sensor: The sunlight sensor can...

We’ve all been there before. You park in front of the store and go inside to do your shopping. After you check out, you exit the store, only to find that you’ve forgotten where you parked. Your car has a...

There are three different ways to cancel a remote start after the vehicle has been turned on: If you want to cancel the remote start from outside the vehicle, you can do so with the remote keyless entry (RKE) transmitter....

You will first need to check to see if the fuel filter is not defective and installed correctly and not backwards. If the filter checks out okay then you may be having another issue that is causing the engine to...

Hi, thanks for your question. This is a common situation when what is known as the mass airflow sensor (https://www.yourmechanic.com/article/what-does-the-mass-airflow-sensor-do) needs to be upgraded, cleaned, or replaced. This is a unit that regulates air flow into the engine as it...

Hello, the transmission will bolt up to vehicle. The difference can be configuration of operating pressures, clutch pack stack and shift points. These codes are for engine and vehicle type match. The transmission will work just may not have...

Hi there. This problem is commonly caused by a frayed or exposed wire within the fuel pump or the fuel pump relay. When the signal is sent to the fuel pump by the ignition relay, the exposed wire will create...

Many of these vehicles came with Dexcool as the coolant. This coolant cannot be mixed with any other types of coolant or it can cause a sludge to build up in the cooling system. I would recommend having your cooling...

It's either motor mounts or an engine management fault (ignition, fuel, air induction, etc. but also including uneven cylinder compression and mechanical issues) or perhaps a combination of the two. The root cause(s) of the problem can be pinpointed if...