Q: I have a 1995 Acura Integra GSR and my cluster won't work, the back lights work but my fuel, temp, rpms, and speedometer

All fuses in your vehicle are technically designed under normal conditions to last the life of the vehicle. A fuses primary job is to open up if the current flowing through the circuit it is protecting exceeds its rated capacity....

Hello, thanks for writing in about your Toyota Camry. You should have the fuel injectors and combustible chambers cleaned of carbon deposits. The build up of carbon on the valves and injectors can cause the engine to run rough (https://www.yourmechanic.com/services/car-idle-is-rough-inspection)...

The "VSC Trac light on" problem is related to a software problem with the yaw rate sensors calibration. This is documented in Toyota Technical Service Bulletin (https://www.yourmechanic.com/article/how-to-use-a-technical-service-bulletin-tsb-to-diagnose-and-repair-a-car-by-valerie-johnston) TSB #BR005-03, which your Toyota service center can apply to re-calibrate this sensor....

Hi there. The stiff steering wheel and flashing Battery Light may be caused by a serpentine drive belt that has broken or come off (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement). It could be that the serpentine belt tensioner pulley was making noise and seized (https://www.yourmechanic.com/services/drive-belt-tensioner-replacement)...

This may be a sign of a dirty or failing idle air control valve. This is a unit that reads the air intake into the motor as it is mixed with fuel prior to being injected into the motor. The...

If you think you have water in your fuel, then you would have one of two problems. You would have a misfire and a rough running engine if there is some water in the fuel but not enough to keep...

This is a common sign of a failing CV joint. A CV (Constant Velocity) joint is a shaft that connects the transmission to the wheels, essentially transferring the power from the drive train directly to the wheels. The CV joint...

Hi there: In most cases, when the wheel bearings go bad, they begin to make the grinding noise on turns, and is progressive as speed increases. This might be an issue with an inner axle (if you're Blazer if 4WD)...

Yes you can swap out the valve bodies as they will bolt right up, however, the computer will need to be replaced for the transmission controller as it is programmed for a 5 speed and not a 4 speed. The...