Q: How I change the engine switch position with the key?

asked by on

How I change the engine switch position with the key?

The engine switch has four positions: Off, ACC, On, and Start. When you insert the key, the switch will automatically be in the Off position. Rotate the key clockwise one position to reach the ACC position, where some electrical components will be available. Rotate the key clockwise two positions to reach On, where all electrical components are available. Rotate the key clockwise three positions to reach Start, where the engine will be turned on.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How I change the engine switch position with the key?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: What is the cost to cut a new ignition key? I live in Lincoln, NE if that matters.

I would suggest calling a locksmith and explain the problem that you have to see if they have the capability to help you out. Unfortunately, I do not think they can but it will not hurt to give them a...

Q: Where is the Coolant Temperature Sensor located?

Coolant temperature sensor is located at the upper radiator hose where it connects to the engine. Should be a green plug connector just to the left of the hose.

Q: Ok my car will not start it had the same issue a week ago I changed the cam and crank sensors. It cranks but wont start ...HELP!

Prior to performing diagnostics be sure you have a fully charged battery that passes a load test. Then, confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. To temporarily override the immobilizer...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.