Q: How do I use the Pass Temp feature?

asked by on December 11, 2015

How do I use the Pass Temp feature?

The Pass Temp feature allows you to change the temperature between the driver and passenger side. This makes them the ride more enjoyable for both the driver and passenger. To use the Pass Temp feature:

  1. Press the Pass Temp button on the climate control panel.

  2. Turn the dial to adjust the temperature on the passenger side.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

How do you adjust sound on a 2012 Ford Escape radio?

While your car’s audio system was designed to provide high quality sound in the default configuration, you may find that you want to tailor things to your personal tastes, or to the type of music you’re listening to at the...

How do I use the driver power window controls?

The driver’s door has switches to control all four of the windows. These switches are set up to correspond with the windows they control (for example, the front left switch controls the driver’s window, while the back right switch controls...

P0113 code high input...changed MAF and ran for 5 minutes then began to idle pop or burp again

The code P0113 is for the inlet air temperature sensor not being correct. In order to test the sensor, you will need a scanner that can access the data of the computer to see what the input temperature the sensor...

The button for my hazards won't depress

Occasionally, these types of switches can get stuck due to dirt, debris or in some cases sticky substances such as drink fluids, etc. In some cases, spraying a very small amount of electrical contact cleaner around it will cause it...

What does the Shift to Park message mean?

The Shift to Park message can appear on the driver information center (DIC). The DIC displays this alert when you need to shift the transmission into P (Park). This message will occur if you try to remove the key from...

Car hard to shift

Hi. It does sound like you might be having hydraulic issues. There are two components to this. The clutch master cylinder and the slave cylinder. The clutch master cylinder is not normally replaced during a clutch job, but the slave...

Air conditioner makes clicking sound when truck turns on, low air pressure unless max AC is used

When the engine turns on, if the A/C switch is off, the compressor clutch is not engaged so the only "noise" should be from the compressor pulley freewheeling. If the air flow is too low at the lower blower speeds,...

Engine running rough

Hello! The running rough symptom on your particular vehicle is commonly caused by a clogged or faulty VCT (Variable Control Timing) solenoid. The solenoid uses oil pressure to determine if the timing needs to be adjusted. The oil is filtered...

Rear pinion seal leaking. Would i also need to change the flange?

The flange is integral with a splined yoke. The yoke segment (of the flange/yoke) has a precision, machined, highly polished surface which mates with the rubber seal. Since the rubber seal is spring loaded and is under tension against the...

Related articles

Why Does the Air Coming Through My A/C Vents Smell Bad?
Over time your car A/C system can start to smell unpleasant. If your A/C system smells bad check for mildew in the vents or install a new air filter.
Symptoms of a Bad or Failing AC Control Switch
As the physical switch controlling AC, common signs include overheating AC parts, certain settings not working, or the AC compressor not turning on.
How Often Does an AC System Need to Get Recharged?
Your car’s air conditioning system is a lot like your home’s central heating and air, and even more closely resembles the system that keeps...