Skip the auto shop - Our mechanics make house calls

Q: How do I use the lane change signals?

asked by on

How do I use the lane change signals?

A: The lane change signals should be used when...

The lane change signals should be used whenever you are changing lanes on the freeway. These signals indicate to your surroundings that you will be changing lanes, by flashing the turn signals three times. To signal a right lane change, pull the Turn Signal lever up to the first detent, and immediately release. To signal a left lane change, push the lever down to the first detent, and immediately release.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: My left turn signal started clicking very fast recently and now when I start the SUV it will run then shut off while in drive.

Hi there. For your situation, check all of the ground wires on the battery, alternator, and fuse boxes. Make sure that the mounting bolts are tight and that the ground wires are clean. Check the battery cables for looseness and...

Q: How do I create a MyKey?

You can create a MyKey with just a few steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until MyKey is...

Q: How do I use the side mounted tool bins?

Your truck comes with side mounted tool bins. These bins are watertight and can be placed anywhere along the side rails. To use the side mounted tool bin. Uncover the lock and unlock the bin with your key. Remove...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...