Q: How do I scan the tracks?

asked by on

How do I scan the tracks?

The scanning feature can be used for CDs, to help you figure out which track to play. To use the feature, simply press the Scan button. The system will then play the first ten seconds of the next track, and then skip to the following track. When you hear the song you would like to play, press the Scan button again to turn off scan mode, and play that song.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I scan the tracks?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How do I turn on the front row map lights?

The front row map lights are located above the two front seats, and provide cabin light for the driver and front passenger. To turn these lights on, press the outer edge of each light. Press the edge again to turn...

Q: How do I tune the radio with the steering wheel?

You can tune the radio with your steering wheel audio controls. Press the Up button for more than 1.5 seconds to play the next radio station, or press the Down button for more than 1.5 seconds to play the previous...

Q: Bought a MR2 roadster that has the Sequential Manual Transmission (bought it as a non driver) Toyota MR2

Hi there - the first task is to get stored problem codes - which may require a Toyota-specific code reader to get the level of diagnostic needed. Sequential Manual Transmissions are very sophisticated, computer-managed units, and very dependent on the...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.