Q: How do I adjust the remote start rear defrost?

asked by on

How do I adjust the remote start rear defrost?

When the remote start rear defrost is turned on, the rear defroster will begin operating when the engine is turned on via remote start. To turn this feature on or off, follow these steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Convenience is displayed, then press the OK button. 3. Press the Up/Down buttons until Remote Start is displayed, then press the OK button. 4. Press the Up/Down buttons until Climate Control is displayed, then press the OK button. 5. Press the Up/Down buttons until Rear Defrost is displayed, then press the OK button. 6. Select Auto or Off.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I adjust the remote start rear defrost?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Car sensor went bad

There are a lot of sensors involved in your AC system. The evaporator temp sensor is the the evaporator, next to the heater core, in the dash. There is a pinpoint test to determine what has gone wrong to set...

Q: Q: How do I extend the seat belt?

If the seat belt is too short for you when it is fully extended, you will need a seat belt extender. A seat belt extender can be found at your local dealer.

Q: Cooling system light on

I think you are referring to the Engine Temperature Light. This light stays on until the normal operating temperature is reached. It should be on when the engine is cold, and then go out after a few minutes of driving....

Related articles

What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.