Q: Have 300RX lexis 2001 it misfires ,slow accleration ,loss powder, I have had full tune-up with all sensor and plugs replaced.

asked by on

Have 300RX lexis 2001 it misfires ,slow accleration ,loss powder, I have had full tune-up with all sensors and plugs replaced. The car ran well for two weeks and reverted back to the old symptoms.

My car has 125 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Have 300RX lexis 2001 it misfires ,slow accleration ,loss powder, I have had full tune-up with all sensor and plugs replaced.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Losing power when I go up hills.

Hi there. When the car is climbing hills and the engine RPM goes up, but is slow to accelerate, it is due to the transmission downshifting to a lower gear ratio. However in some cases, the lack of acceleration can...

Q: Washed Engine Now Car Won't Start

Washing an engine is a risky business. If you're going to have it done, it's best performed by a technician who will know where NOT to direct the spray. Now that it has been done, you could have a failure...

Q: 2008 lexus gx470: car bouncing even after $3500 shocks were replaced on front and back

If the ride height is within spec, that is the coil springs are not weak, the only cause of the vehicle failing to settle immediately (i.e., bouncing) after encountering road irregularities is defective shocks or defective strut assemblies with built...

Related articles

How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.