08 F550 DIESEL 6.4 HARD START AND WHEN IT SATAT IT MISES ...


08 F550 DIESEL 6.4 HARD START AND WHEN IT SATAT IT MISES I THINK IN TWO CYLINDS Mechanic's Assistant: How old is the [engine](/topics-engine-ford/)? And when was it last serviced? IT IS AN 2008 IT WAS ABUOT 6 MONTHS AGO ...

08 F550 DIESEL 6.4 HARD START AND WHEN IT SATAT IT MISES I THINK IN TWO CYLINDS Mechanic's Assistant: How old is the [engine](/topics-engine-ford/)? And when was it last serviced? IT IS AN 2008 IT WAS ABUOT 6 MONTHS AGO Mechanic's Assistant: Are you fixing your F550 yourself? What have you tried so far? YES I GOT 3 CODES Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? P0684 P2289 P0672 THAT IS THE CODES

Automotive Expert
Howdy from Tennessee, I'm Chris aka Moose. Who am I helping today? I'm glad you've come here to get help. I will do my best to get the answer you are looking for. I help many customers, so sometimes my replies are delayed, I will respond once available. I try to be online at 1-5 pm and 10 pm-5 am every day. - Have you started doing any of the diagnostics for these codes and if so are you stuck at any steps or do you need the diagnostic steps? - Once it warms up, does it run better?

WHEN IT WARMS IT STARTS TO LEVEL OUT
Automotive Expert
- Have you started doing any of the diagnostics for these codes and if so are you stuck at any steps or do you need the diagnostic steps?

please call thanks
Automotive Expert
Can I get your first name before I call? Chris
Automotive Expert
Phone call session started
Automotive Expert
The call has gone to another tech. So you will be getting help from them on the call instead of me. Concerning the fuel rail pressure sensor and glow plug issues. Keep in touch as needed.

ThanksLance
Automotive Expert
You are welcome. Hopefully, the tech that called got you fixed up.

What others are asking

How do I answer or reject an incoming phone call through Uconnect?
If your phone is paired with your Uconnect system, then phone calls will automatically come through your speaker system when you are in the car. If you are listening to the stereo system, Uconnect will interrupt you to let you...
Car roaring at 60 MPH.
The noise you may be hearing is the rear axle bearings at high speeds. The vehicle should be checked (https://www.yourmechanic.com/services/car-is-making-a-noise-inspection) by a qualified mechanic and the rear engine may need all the axle bearings replaced or the gears may need...
Brake light and battery light flashing after replacing HID's, alternator and battery
It sounds like it may just be happenstance that the HID light bulbs were replaced and then the other problems started. The battery light is set to come on when the vehicle detects the alternator output is below 12 volts....
Electronic door lock/unlock can't be unlocked from inside car
Hello. Most of the time this is caused by a malfunction in the door lock switch (https://www.yourmechanic.com/services/door-lock-switch-replacement). I have seen the switch short internally and cause this. I have also seen the control module for the locks fail, keeping them...
The mechanic said my son's car is leaking grease. What does this mean and what are the dangers?
Hey there. Your son's car has something called a constant velocity (CV) joint (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement) which is essentially the drive axle that transmits power from the transmission to the wheels. These CV joints have rubber boots that surround them to keep...
Truck wont seem to shift into park.
Since the transmission does shift into park with the shifter disconnected, the problem lies elsewhere. Most likely the issue lies in the shift interlock system. It could be a faulty ignition lock cylinder not triggering the interlock system to allow...
1992 Honda Accord cooling fans not operating properly.
Hi there. Your issue is the ECT (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement) sensor B is not closing the loop when engaged. There is power to the sensor A from the computer, but the sensor B is not connecting when the vehicle is running hot...
2011 Scion XB ECM replacement cost.
Hi there. The time to replace an ECM (Engine Control Module) on a 2011 Scion xB with a L4-2.4L engine is around 1 to 2 hours not including programming the ECM. ____________________________________________ Billing question was sent to CS for the...
Coolant does not return to radiator after cool down
Hi there. Coolant is circulated through your engine block, heater core and back to the radiator thanks to the water pump. If the coolant does not circulate back to the radiator to be cooled, it is either due to an...