Q: Explorer Serpentine Belt

When you say "not working well", it sounds to me as though the actuator could be getting weak, since this door gets locked, and unlocked the most. I recommend having the lock actuator replaced, after it is checked. I recommend...

The first thing to determine is whether the problem involves the engine, or transmission. If the engine is running rough, or the turbo is not working properly, the engine will be down on power, and will not accelerate as it...

A no-start condition can be caused by many things, and is sometimes one of the most difficult problems to diagnose. It may be possible that the rain may have something to do with this. No-start conditions can be caused by...

This may be a variety of things, such as wheels and tires out-of-balance, poor alignment, worn or failing wheel bearings (https://www.yourmechanic.com/services/wheel-bearings-replacement), worn or failing control arm bushings (https://www.yourmechanic.com/services/control-arm-assembly-replacement), or worn or failing suspension components. A wheel bearing will usually fail...

Hi and thanks for contacting YourMechanic. First, with the dirty cooling system, you would need to perform a coolant flush and replace the thermostat (https://www.yourmechanic.com/services/thermostat-replacement) and radiator cap (https://www.yourmechanic.com/services/pressure-test-radiator-cap). This will help with the overheating issue if you are still...

Hi there: The P1095 ODB-II trouble code indicates that the O2 sensor signal circuit is slow switching from lean to rich (Bank 1 Sensor 1). When this occurs, it can cause your vehicle to stall rather quickly. However, before you...

Hi there. Unfortunately, our mobile mechanics do not offer engine swap services in North America, so we're really not best suited to answer this question for you. The best advice we can offer is for you to contact a local...

The issue you are writing in about is common enough that a specific diagnostic, namely a reduced engine power diagnostic (https://www.yourmechanic.com/services/reduced-power-light-is-on-inspection) is performed by technicians dispatched by YourMechanic. If you request that diagnostic, the responding certified mechanic will get this...

Be sure that the gear shifter is actually selecting the reverse position; you can observe the manual lever on the transmission case to see if the lever is in the commanded detent position. If the transmission is in reverse, pressure...