Skip the auto shop - Our mechanics make house calls

Q: Cuts off while in idle postion

asked by on

My GM cuts off while in idle position

It sounds like you may have a dirty or failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. This valve is controlled by the vehicle’s computer and will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. This is also an important function when starting the motor as it allows the motor to run and idle on it’s own once the motor fires. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed while adjusting the air/fuel ratio constantly to allow this to happen smoothly. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and replace your idle air control valve.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: 06 dts 110k new plugs and packs started idle shuttle hesitant at first then stops bought car used i believe fuel filter is origina

Hello, thanks for writing in about your Cadillac DTS. The fuel filter and fuel pump may be the cause of this issue. You should have the fuel pressure tested first to see if the fuel pump is failing. Replace the...

Q: Car starts, then dies. Also dies when idling.

The idle air control valve probably needs cleaning or replacing. I would have a technician replace it. They are fairly inexpensive.

Q: What causes the engine to run rough and the engine to die when the accelerator is pressed?

Hello. You have covered most of the common parts that fail with the exception of the idle air control valve/module. This is a unit that works similarly to the mass air flow sensor as it regulates the air intake into...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...