Q: Check Engine light came on

asked by on January 20, 2016

My Check Engine light is on, as well as another light.

Check Engine Light is on Inspection $79.99 - $99.99 Get a Quote

Multiple lights may be caused by multiple problems.Your BMW has a few dozen computers which can trigger warning lights to appear on your dash. Diagnosing multiple problems may be time extensive, but can be performed by a qualified technician with the right diagnostic tools. A qualified technician, such as one from YourMechanic can assist you in diagnosis and repair.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car stops while driving, already replaced the throttle body. Have codes p2106, p2110, p1516

Hello, thank you for writing in. The Chevy Aveo has had many issues similar to yours. There may be a TSB out on the issue. These are Technician Service Bulletins. They are released by the manufacture when there is a...

How do you know if the ignition needs to be replaced when you replace the plugs on dodge 5.7 hemi?

Hi there. To determine if the ignition coils need to be replaced, remove one park plug wire at a time and hook it up to a spark tester gauge and set the gauge to 10 thousands gap and increase it...

Wrench light and engine light on

Generally, the check engine light comes on when something fairly serious is going on with the vehicle. This can happen for many different reasons such as a faulty mass air flow sensor, a faulty O2 sensor, a bad catalytic converter,...

When replacing my ball joints on my 2005 dodge Strauss do I need to replace the control arms as well

Hi there. When changing out the ball joints, you don't need to change the control arms if you have a replacement ball joint. However, if you are wanting to replace the bushings and the ball joint, then you may get...

My timing belt broke what should I do? Can I drive my car?

Hello, thank you for writing in. The timing belt is responsible for keeping the camshaft and the crankshaft in sync so the valves will open and close accordingly. With that said, the vehicle is likely not going to run at...

My car's center console has no power

Hello. If your center console and radio unit is no longer working after the battery is disconnected then it may be possible that a fuse has blown. I would check the vehicle's interior fuse box to see if any of...

Key on, no start and no dash lights. 1996 Ford Explorer

Hello. This is likely a loose terminal or corroded battery connection. Make sure the cables and terminals are clean. Also check the ground in the engine compartment. It sounds simple, but something like this can easily cut all power to...

Car stalls after reaching operating temp

Depends on if the engine is overheating or not. It would not stall on turns only, if it was overheating. It would stall a lot more often than that. You may have a problem with the EGR valve sticking open...

Related articles

How to Replace an Air Fuel Ratio Sensor
The air fuel ratio sensor fails within a vehicle if the check engine light comes on. Poor engine performance results from oxygen sensor failure.
P2630 OBD-II Trouble Code: Heated Oxygen Sensor (HO2S) Malfunction
P2630 means that the O2 sensor circuit signal that falls outside a range due to a faulty sensor, a short, blown fuse, hi/low fuel pressure or, a leak.
P2243 OBD-II Trouble Code: O2 Sensor Reference Voltage Circuit Open Bank 1 Sensor 1
What What the P2243 code means? P2243 is an OBD-II generic code for the engine control module (ECM) detecting the O2 sensor for bank 1 sensor 1 having an open circuit for the reference voltage to the O2 sensor. ...