Q: Car jerking when idle or acceleration

asked by on

After filling up car from E to Full my car started jerking when idle or slower speed once at a good steady speed jerking stops I removed the gas and changed o2 sensors w no luck

My car has 159000 miles.
My car has an automatic transmission.

Hello, It sounds like you may have a problem with your Evaporative emissions control system. Your car has a small purge valve called a purge solenoid that controls the venting of fumes from the fuel tank as these fumes build up inside, particularly when you are refueling the car with gas. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors in the charcoal canister. The charcoal canister is filled with activated carbon pellets that can absorb the fuel vapors. When the engine is running, the fuel vapors are purged from the canister and burned in the engine. The vent control valve (solenoid) controls the flow of outside air in and out of the charcoal canister. The vent valve is controlled by the engine computer (PCM). Normally the vent valve is open. It closes when the engine computer tests the EVAP system for leaks. If a leak in the EVAP system is detected, the Check Engine light will illuminate on the dash and the trouble code related to the problem will be stored in the engine computer. When an air leak is present in the EVAP system, the MAP sensor will not be able to determine the air density, and the MAF sensor will not be able to determine the volume of air, entering the engine correctly. This will lead to an over fueling situation or an under fueling situation depending on the size of the air leak and engine operating speeds and load. This may eventually lead to catalytic converter problems as well as misfiring problems. I would recommend having an expert from Your Mechanic come to your location to diagnose and inspect your vehicle.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Car jerking when idle or acceleration

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I can feel the front of my car shaking at 65 (or so) mph, especially if I am turning.

This may be related to out of balance tires or potentially an alignment problem. This may also be related to control arm bushings. When a tire or wheel is out of balance, this will cause a shaking as you describe...

Q: Car temp rises when ac is on

Certain engine management issues, such as too lean operation, engine timing issues and so forth can contribute to overheating. The reason the overheating is occurring whenever the a/c is on is because a/c adds a load to the engine, making...

Q: A/C problem on 06 Mitsubishi Lancer ES

If you are getting power to the compressor but the compressor clutch is not engaging then you may have a bad clutch coil. Sometimes the clutch coil will get weak and not be able to engage the clutch when it...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.