Q: Can I reapply the pulley ring to my ac compressor bearing?

In most states in the USA, if you have an exhaust leak (https://www.yourmechanic.com/question/exhaust-leak), you will fail that state’s annual safety inspection. The vehicle will then be rejected for safety due to exhaust gases such as NOx, carbon monoxide, and many...

Hello. This engine typically overheats from a failing thermostat or possibly a more serious issue. I would typically start by checking the coolant level and running the engine until it gets hot. I would then make sure that the fan...

If your car jerks when you put it into reverse, that could possibly be caused by your motor mounts. Worn motor mounts will not support the engine, and it will move when throttle is applied. I would recommend having a...

The ignition module failing after getting hot is the most likely failed part causing the stall. There can also be a problem with the fuel pump or sensors. I recommend seeking a certified mechanic, like one from YourMechanic, to come...

Hello, thanks for writing in to YourMechanic. If the caliper boot is torn open then you will get dirt, debris, water, and road salts in the caliper piston surface. The caliper may seize or tear the caliper piston seal causing...

Yes, it is possible to add an external horn, although it is not clear to me why an additional horn (in addition to the original horn) would be necessary to pass Virginia inspection. YourMechanic can perform a Horn Replacement Service...

You could have both of those problems. The ticking sound when you turn is most likely the CV joint. As for the vibration at a stop, an engine mount (https://www.yourmechanic.com/services/engine-mount-replacement) will usually show signs while driving as well, but not...

Hi there. The The vehicle stability assist (VSA) Off light is located on the instrument panel and illuminates whenever the VSA system is deactivated. When the VSA system is reactivated, the light will disappear. In general, when the ! light...

If you have already found the reason for the fuel flooding the cylinder then you will need to remove spark plugs and disable ignition and turn over motor to get out excess fuel. Then you will need to replace the...