Q: Blower motor and a/c compressor stopped at same time, relay and fuse are good and changed control panel. 2006 E-250 4.6

Hi. Your concern sounds very similar to an event where the system cooling fan may not be working properly. If the air conditioning is cooler as the vehicle is moving, but warm when stopped, this tells me air flow is...

If the transmission will not go into gear and the clutch pedal is loose, it generally means a failure in either the clutch master or slave cylinder. The clutch hydraulic system will need to be checked. For your clutch, you...

Hello. The main question is why does you think your computer needs to be reset. If you have engine idling issues, then there is a relearn procedure procedure which can be performed with an advanced aftermarket scan tool such as...

Hey there. There is a 40 amp fuse and a separate relay in the engine compartment fuse box (https://www.yourmechanic.com/article/how-to-check-fuses-by-rocco-lovetere). If the problem persists after installation, or you need help having this installed, an expert technician from YourMechanic can come to...

This could be traditional "turbo lag" - I would check the turbocharger boost control components for air leaks, or poor electrical connections. I would also check the throttle position sensor, which may not always be recognizing your foot pressing the...

The vehicle with this engine size is equipped with a primary and a secondary thermostat in the cooling system. The primary and secondary thermostat open at different temperatures. The secondary one opens up at 203 F and should be fully...

Hi There, This kind of ticking sound is usually related to valve train noise that is caused by the lack of oil circulation or out of adjustment valve train components. This is somewhat common to a certain extent when the...

Your vehicle has a neutral safety switch (https://www.yourmechanic.com/services/neutral-safety-switch-replacement) that will prevent the vehicle from starting when it is in any gear position other than park or neutral. Occasionally, this switch can malfunction causing the car to stall as soon as...

Generally, an oil leak should not cause a serpentine belt to come loose, however depending on the source of the oil leak and the severity of it, it could be possible. I would suggest having the serpentine belt tensioner checked...