Q: Antifreeze leak

asked by on November 27, 2016

Leaking antifreeze n don't know what could b the problem

Coolant is leaking Inspection $94.99 - $114.99 Get a Quote

The cooling system that is leaking and over 13 years old could be most any component in the system. The cooling system will need to be pressure tested to locate the leaks in the system. The radiators and expansion tanks are known to get heat stress cracks over time. This is why the system will need to be tested by a mechanic like one from YourMechanic that can come to you and using a pressure tested find the cooling system leak and then a quote for the needed repairs that will be needed to fix the cooling system.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Engine makes noise
This is not a common problem. The engine may have been starved of oil and the only way to tell is to do an oil sample to see what failed inside the engine unless a rod is sticking through the...
Gas line leak
Hello. You would know if you have a leak in your gas line because you would see gas leaking on the ground or a heavy has smell in the cabin of the vehicle. You would also notice your gas burning...
The car turns off suddenly, no check engine light
Hi there. If the vehicle is just randomly turning off like this, it is almost always caused by a bad crank position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) on this engine. This is very common and it will not turn on the Check Engine...
Nothing turns on the car
From what you've described you may just have a bad battery connection. You should first have the vehicle jump started to see if it stays running and look for any lights that may have been left on. Once the jumper...
Bank 1 too lean
While a bad O2 sensor can be the cause of a 'lean" fault code, it can be set for a number of reasons. A vacuum leak anywhere in the intake system can cause a lean fault as can other sensors...
Vibration Under Acceleration
You may be dead on about the CV joint, the car certainly does have enough miles on it for the joint to be bad. CV's will respond to the torque load as well as changing direction, so your analysis is...
How many litres of oil will new gearbox will contain
Hello. Your Murano will need 10.2 liters of fluid if it is dry. When the gearbox is new it should be empty and need a dry fill. Make sure that you use genuine fluid from Nissan.
Car won't start and security light is flashing?
The Pass-Lock security system can be effected if the battery was disconnected or dead, as well as if something like the ignition switch was replaced. Try these steps below. The Passlock has two basic relearn procedures—a ten-minute procedure and a...
Rpm goes up and down stutters.. without pressing on accelerator
Hi There, It sounds like you may have a dirty or failing idle air control valve causing your engine idle to fluctuate. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) is a small valve on the engine's intake system that reads the...

Related articles

2012 Hyundai Elantra vs. 2012 Ford Focus: Which One Should I Buy?
The Hyundai Elantra and the Ford Focus are both offerings in the inexpensive compact sedan category, and both represent some of the best offerings in that class. Compact cars are slightly larger than a subcompact, but smaller than a mid-size;...
The Best Used Cars to Buy That Can Be Towed Behind an RV
Summer Summer is a great time for a road trip, but often travelers like bringing all the conveniences of home along, in the form of an RV. Then they tow their car behind it – sometimes this practice is called...
Symptoms of a Bad or Failing AC Accumulator
Common signs you need to repair your AC accumulator include rattling noises during operation, noticeable refrigerant leaks, and a moldy smell.