Q: Evap system leak

asked by on

Check Fuel Inlet Message pops up on my dash. My gas tank is made with no lid. What is causing this Response on my dash? What do I do?

My car has 90000 miles.
My car has an automatic transmission.

It sounds like you may have an evaporative emissions system leak. Your car has a small purge valve with a purge solenoid in the Evaporative Emissions system that controls the venting of fumes from the fuel tank as these fumes build up inside, particularly when you are refueling the car with gas. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors in the charcoal canister. The charcoal canister is filled with activated carbon pellets that can absorb the fuel vapors. When the engine is running, the fuel vapors are purged from the canister and burned in the engine. The vent control valve (solenoid) controls the flow of outside air in and out of the charcoal canister. The vent valve is controlled by the engine computer (PCM). Normally the vent valve is open. It closes when the engine computer tests the EVAP system for leaks. If a leak in the EVAP system is detected, the Check Engine light will illuminate on the dash and the trouble code related to the problem will be stored in the engine computer. When an air leak is present in the EVAP system, the MAP sensor will not be able to determine the air density, and the MAF sensor will not be able to determine the volume of air, entering the engine correctly. This will lead to an over fueling situation or an under fueling situation depending on the size of the air leak and engine operating speeds and load. This may eventually lead to catalytic converter problems as well as misfiring problems. I would recommend having an expert from Your Mechanic come to your location to diagnose and inspect your vehicle.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Evap system leak

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: New battery and recently got a alternator couple months ago car still dies

The alternator is not recharging the battery after you start the vehicle. Since you replaced it recently I would recommend having it checked to see if it has stopped charging or you have a wiring problem from the alternator to...

Q: Auto start stop dissconnected check engine warning message and light 2014 Ford

Hello - most likely the throttle position sensor (part of the electronic throttle) has a fault. Since the "auto stop-start" mechanism depends heavily on successful operation of the TPS, any quirk would endanger safe operation of the "start" sequence. Software...

Q: It runs good when its cold then dies when warm let it cool off runs and drives fine

Heat changes the electrical resistance, and thence operation, of electrical components. That is possibly the underlying issue. The way to diagnose this is immediately after the shut down. If the vehicle is not starting at all, once hot, a no...

Related articles

What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.