There are a variety of things that could resemble a hose hanging from the bottom of your car. Without additional information related to the steering symptoms it would be tough to say specifically. Some things to consider are: Does the...
Hello. There may be a problem with the electrical system, which includes the battery, starter, and alternator. In addition to the starter relay that you just had replaced, it is possible that the starter itself needs to be replaced. I...
Hello. If you are not able to get pressure to come to the calipers, you will have to use a scan tool to activate the bleed function of the abs. Otherwise, you will not be able to get fluid out...
This oil pan requires removal of the starter, front engine mount bracket, torque converter dust shield and then oil pan bolts to get off pan. Once the pan is cleaned then the gasket sealer is installed using a 1/8 inch...
If your vehicle has an EVAP system leak, the Check Engine Light will normally illuminate, because a Diagnostic Trouble Code has been stored, and the Mechanic can use the Code that was stored to start his or her Diagnosis. The...
Hi there. Check all of the vehicle grounds to the lighting circuits and the ignition circuits. Make sure that the grounds are cleaned and tightened. A loose ground will cause circuits to malfunction and not work correctly. If you need...
Hello There, It sounds like you may have two separate issues going on here. The squealing sound is likely your brake pads which have wear indicators on them that are designed to produce a squeaking sound signaling that it may...
Hi there. Sounds like the engine may have water in the cylinder, fuel in the cylinder, or the timing chain may have broken. Try turning the engine over by hand with a breaker bar. If the engine will not move,...
Hi there. Assuming, the engine ran fine prior to replacing the "front?" crankshaft seal, leads me to believe the reassembly process was incorrectly performed. Rechecking timing marks and correcting the alignment may resolve the no start condition. It would be...
Hi there. A speedometer is controlled by a few different components including the speedometer cable, speed sensor on the transmission and wheel sensors. Any one or multiple parts can fail, leading to the speedometer to fail. It's probably a good...
Hi There, Your vehicle has something called a neutral safety switch that will prevent the vehicle from starting when it is in any gear position other than park or neutral. Occasionally, this switch can malfunction causing the car to stall...
Hi there. To be honest, you lost us at swapped ECU twice with junkyard units. The problem with replacing OEM ECU and not having them correctly programmed by the dealership is that any realistic chance of diagnosing a misfire issue...
This sounds like it could be related to the emissions system. Something is overheating. It may not be the engine but a component of the emissions system such as a purge valve. This could prevent flow of the fuel or...
First of all, a shop cannot let a vehicle leave the parking lot with the engine light on without your signature saying that you intend to leave with the light on. Second of all, the light might have been on...
Hi there. When this occurs, it's typically due to a coolant line breaking (in most cases, one towards to the top of the motor). This could also be caused by the radiator cap breaking or an overheating problem. Regardless of...
The chugging is being caused by either the fuel monitoring system (fuel injectors or throttle body injection) is metering too much fuel into the cylinders or the fuel filter could be plugged up causing the fuel system to drop in...
Hello. If there was transmission fluid getting into the cooling system previously then it will take some time to get that oil out. It may take several flushes to clean it as long as there are no other issues. As...
If your vehicle is equipped with anti-lock braking, you have to either bleed the ABS pump and valving (per Factory Service Manual instructions) or use a bi-directional scan tool to remotely actuate the ABS system during brake bleeding. Otherwise, in...
You should first have the charging system checked to make sure it is not overcharging since these alternators are known to have this problem. If an overvoltage condition is present it could have blown the high beam circuit inside bulb....
Hello - no, the motor mount from a '98 will not fit your 1992. The Voyager changed in 1996, with an additional engine choice in '99 - motor mounts also. Motor mounts from a 1991-1995 Voyager (for the same engine)...
