Popular questions

Hello there, many different faults will cause your 2009 Nissan Rogue to have a vibration issue at higher speeds. The most common causes are wheel/tire balance, failed suspension components, wheel bearings, ball joints, or an engine mount. Vibration issues are...

An inertial type fuel pump cut off switch was not used on the 1999 Elantra. However, there are other solenoid operated fuel cut off switches on the vehicle, in the tank area, that could account for the no fuel condition....

If upon actuating the ignition switch you hear "crackling" noise in the dash, that could be due to arcing or a faulty component such as a relay that happens to be in the circuit that you are powering with the...

This condition sounds like one BMW has noted on a technical service bulletin (TSB) concerning a software issue in the engine control module. There has been an updated software version developed by BMW but you will need to have this...

Your rear seats have four lower anchors that can be used with any LATCH (Lower Anchors and Tethers for Children) child restraint system. The lower anchors are located on each side of the rear outboard seats, where the seat cushion...

Hi there. Check the transmission and see if the cable is moving when the shifter is moved from the park position to the drive position. If the cable is not moving, then either the cable is broken or the shifter...

Hello - I suspect this may be a problem with the fan motor resistor pack. If the fan control is put in the "Max" or "High" speed position, does the fan continue to run? Does the fan only run for...

Well you replaced all the parts associated with your code. You need a voltage meter to measure the voltage at the sensor. There should be a 5 volt signal and a ground on the outer wires on the sensor. If...

From your description, it sounds like the starter motor is not functioning. In attempting to start the engine, if you do not hear the engine turning over, that is there is no starter motor function at all, the starting circuit...

You could have both of those problems. The ticking sound when you turn is most likely the CV joint. As for the vibration at a stop, an engine mount will usually show signs while driving as well, but not always....

Hello - to be sure, a leaking valve cover gasket that is allowing oil to leak onto the plugs, plug boots or coils, will cause misfire issues, and uncertain engine starting performance. I recommend a car is not starting inspection...

There are a number of things that may cause the vehicle to stall while driving. This can happen for any number of reasons such as fuel supply issues such as a bad fuel pump, vacuum leaks, electrical faults or various...

It sounds like you may have a broken or damaged sway bar or stabilizer bar. A sway bar or stabilizer bar is a steel bar that connects suspension components on opposite wheels. Its purpose is to combat body roll when...

Your engine design is of the "interference" type. That means that if the timing belt was not installed correctly (or breaks when the engine is running) and thus the camshaft(s) turns out of synch with the crankshaft, the valves can...

The most common methods to deal with this situation are to put the key in each door and lock and unlock to reset the alarm. You may need to do this in the trunk or hatch lid as well. The...

Hello. I would recommend checking a Chilton book to determine where the timing marks for the crank pulley are located. Chilton books provide an abundance of information that will help in diagnosing and repairing your vehicle. As for the fuel...

Hello. From what you describe it would appear that the aftermarket alarm system may be having an issue. If the alarm has done this since it was installed then it may be possible that it is wired improperly, or that...

If you are producing too much NOX this means your combustion is running too hot. This is usually caused by the engine running too lean or the EGR system is not flowing enough to cool the combustion. You should remove...

Hello. You may have a wheel bearing going bad or flat spot on your tire. I suggest that you have a technician such as one you can choose from YourMechanic perform a suspension evaluation on your vehicle to help you...

The sun roof drains are plugged in the channel that is in the front. Open the sun roof and look in the rain channel and look for the drain holes. Try and pour some water in the hole and see...

It sounds like your transmission is having a problem with one of the inputs, which helps it determine when to shift. It could be a hydraulic problem, or a problem with one of the solenoids as well. Start by checking...