Popular questions

Question
I replaced my clutch and bleed my hydraulic clutch master cylinder. But when I put the truck in 2H and try to shift, I won't shift.
Hi there. There seems to be an issue with the transfer case on your vehicle. The transfer case may have a bent fork or the shifter synchronizer has broken teeth. I recommend seeking out a professional, such as one from...
Question
Car jerks when i put it gear
Assuming your car has an automatic transmission, it sounds like you may be low on transmission fluid. Automatic transmissions use transmission fluid that is pressurized to shift gears. When the transmission is low on fluid, this can cause delays in...
Question
Popping sound when turning.
Hello, It is quite possible that a bent bracket will cause a popping sound as you describe. When a car makes a sharp turn, the part of the bar on the outside of the turn gets pushed down toward the...
Question
Engine Died Car wont Start
It is possible that some engine damage may have occurred when this happened. Full Throttle is typically not recommended on many vehicles as it can cause the engine to Red Line. I would recommend having your vehicle inspected by a...
Question
Car won't start, engine ticking
Hello. It sounds like the battery is weak and does not have enough power to start the car. Even though the lights come on in the dashboard, it does not mean that there are enough volts for the battery to...
Question
Car wont reverse gear
When an automatic transmission starts to fail, reverse is frequently the first to go. Your transmission has a number of clutch disks and bands in it that have a friction lining much like a conventional clutch and like a conventional...
Question
Engine light on and vibration
The cause is more likely to be in engine related controls or sensors but nothing can be ruled out until an actual and thorough diagnostic is performed. Inasmuch as the check engine light came on, there will be critical clues...
Question
Performance issues when driving and idling, RPM dropping abruptly
The symptoms you are describing are almost always caused by a bad catalytic converter. When this fails it clogs the exhaust, which causes these problems to occur. Do a back pressure test on the exhaust first. If that is fine...
Question
Engine light flashing intermittently
This may be related to a faulty or dirty mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected into...
Question
My truck seems to have a late reaction time to the accelerator.
This could be a variety of things ranging from poor fuel delivery to vacuum leaks. In the case of a vacuum leak, when you step on the accelerator and demand a quick increase in air/fuel flow to the intake system...
Question
What do I do to get my car started. Neither ignition key will start car
To determine if an easy resolution exists, please refer to YourMechanic's DIY stuck key remedies page. If none of the many suggestions on that page resolve your issue, it will be most efficient if a certified mechanic travels right to...
Question
I have a query on used 2008 Land Rover Range Rover car maitenance cost and the common problems faced by it.
Like any other luxury brand, a Land Rover's cost of maintenance is above average. This is due to parts being specialized, and a lack of aftermarket replacement part options; but also simply because of the name. Land Rovers are typically...
Question
Camshaft position sensors control what part of engine
Changing the Camshaft Position Sensor (CMP) might solve your problem, but probably won't. The P0016 code is saying that the CMP signal is there, but not at the right time. The Camshaft must be timed precisely to the crankshaft and...
Question
Many warning signs via gauge cluster
Intermittent, and ultimately unexplainable, electrical glitches can and sometimes do occur. They can represent "one off" incidents and thus they don't recur. However, it is also possible that you have an incipient, and thus real fault. One thing you, or...
Question
What makes my transmission so rough?
In order to tackle this question appropriately, more information would be needed to guide us in the right direction. One question is, does the transmission slowly engages when you first drive your vehicle, or after it has sat for a...
Question
Squeal when engine starts or revs.
With having already replaced the belt and the idler and tensioner, I would look at the components next. Something like the bearing or bushing going out in one of the other driven components. The alternator, the power steering pump, or...
Question
Rough idle when stop on D mode...
Hi there. This may be a sign of a failing idle air control valve. The idle air control valve is located on or near your intake manifold that monitors the air intake as it is mixed with fuel prior to...
Question
I would like to know what can be causing my coolant to drain quickly to the point where i have to re fill it every 2 days no leaks
There is a leak somewhere and if there is no leak, from an external source, then the engine is leaking internally. My recommendation is to have a coolant pressure test and a combustion leakage check on the radiator. This will...
Question
A warning beep comes on every 10 seconds (just one beep)
Hello there, many faults can cause a beeping noise in your 2004 Dodge Stratus. The most common would be the seat belt warning light. This can occur if the passenger seat sensor is faulty. A qualified technician such as one...
Question
Loud Knocking Noise Coming From The Right Upper Side Under My Hood .
It sounds like you could be having a fuel delivery issue if your vehicle is not able to stay running. It is also possible that your engines knocking sound could be part of the reason it is dying. I would...
Question
How do you use the Daytime Running Lights?
If your car is equipped with Daytime Running Lights (not available on all Fusions), they provide substantially better visibility during daytime driving. Unlike your headlights, the Daytime Running Lights are designed to make your car more visible to other drivers...
Question
I have a 2007 Chrysler Sebring. The gear shaft is in park but the dash shows it in Drive. The car will not start now. The red ligh
The engine might not start because the neutral start safety switch "thinks" the car is in drive. There is a problem with the selector, the switch and/or the shift/gear selector cable adjustment. To figure out which of the three, the...
Question
Runs rough, replaced crankshaft position speed sensor
Hello, The crankshaft position circuit is the electrical circuit for the crankshaft position sensor. If the sensor has been replaced, then it may be possible that the wiring or connector that goes to the sensor is having an issue. If...