Popular questions

Hi there - since the engine type is "R" for both VINs (position 8 in the VIN), yes, these engines should be compatible. I would recommend using the engine management (computer) and engine wiring harness from the donor vehicle, just...

Hi there. Trying to diagnose this type of problem is incredibly difficult, so I totally understand the frustration. Usually, when this type of issue occurs, it is due to a loose electrical connection to an ignition system component, such as...

This can be caused by a number of things such as low coolant levels, a faulty thermostat, or a failing coolant fan switch. As you may know, the coolant fan switch helps to maintain the proper coolant temperature by turning...

Unfortunately, there is no definite way to tell how much longer your engine will last. Generally, a cylinder needs at least a minimum of 100 psi in order to run. In your case, this is not happening, which means the...

Hello, thank you for writing in. The vehicle does utilize a lot of the same sensors for these systems. Are there any other codes that are coming up when this code appears? If so you will want to take these...

If your car is equipped with seat heaters (optional equipment), they provide an additional solution of comfort during cold weather, as well as for easing an aching back. Using them is actually very simple. Here’s what you need to know:...

Hello, the fuel pump relay is located left front strut tower engine area. It is housed in a fuse and relay center. The fuse for the fuel pump relay will be close to the relay. There may be a location...

This is a common issue on your vehicle. The intake manifold on your vehicle is made of plastic and mounts to an aluminum cylinder head. These materials expand and contract at different temperatures and this creates leaks. This problem is...

Hi David, Generally when the secondary air pump goes bad, this will cause the motor to run rough due to the incorrect readings being generated by the oxygen sensors as well as overall lack of horsepower. This is all caused...

If the engine has a rod that went through the block or oil pan then you may have damaged the engine block beyond repair. I would recommend having a mechanic inspect the motor and check for a possible engine swap...

Magnasteer was not an option on the 2011 Impala so what you are looking at is an irrelevant catalog entry (an error in the parts catalog). However, several different rack and pinion units were installed on the 2011 Impala and...

Hey there. If the coolant reservoir is leaking, then it could leak out enough coolant to cause the engine to overheat. The reservoir is known to get stress heat cracks and leak coolant. You might see a small pinpoint leak,...

If you have an engine that is running rough and misfiring and the exhaust is sucking in sometimes then you may have an exhaust valve that is sticking open. You should have a compression test to the motor. The valves...

Hello. If the engine is having trouble starting after it has ran for a while and you are getting the smell of fuel, then it may be a failing fuel injector or an issue with a bad sensor. Most of...

You might have a problem with the oil filter leaking when you rev the engine and increase the oil pressure. This can be from a collapsed oil filter media or excessive oil pressure from the engine. I recommend having the...

Darlene: It is a fable. The only approved repair for a head gasket leak on your vehicle, according to the exhaustive instructions provided by Ford Motor Company in the Factory Service Manual, is to remove the old gasket and replace...

Hello - for virtually all modern cars, setting the heater/AC controls on any position that utilizes the air conditioning compressor (i.e. defrost), the auxiliary fan for the radiator is automatically turned on to increase airflow over the AC condenser coil...

Internal engine components each have their own signature noise. An experienced technician can often get a good idea of what is causing a knock by listening to the sound. A connecting rod bearing usually sounds off when you rev the...

As you may know, the cost to rebuild a motor may vary widely due to the many options available and potential supply of parts or the damage done to your existing motor. Typically, you can find long blocks for this...

I think you have it backwards. The pads and rotors do not cause bad calipers, but a sticking or binding caliper can cause the pads to wear excessively and cause the pads to dig into the rotors. The calipers may...

Hi there. Most of the time this type of problem is caused by an electrical short in the turn signal switch or steering column. I wouldn't say this is a very simple fix, due to the fact that locating the...

You've got to realize that it depends on how you drive and where you drive. I personally change my oil in my own car every 3,000 miles because I don't drive that much. I don't even drive 3,000 miles a...

Hello. If your lights are coming on and off then there may still be an issue somewhere with the vehicle. If there was a recent reset due to an issue with the crank position sensor it may be possible that...