Popular questions

Hello there, thank you for asking about your 1994 Suzuki Samurai. If these accessories share a common ground, some corrosion may be connecting circuits that should not touch. You will want to hire the services of a technician experienced in...

The most common problem with this condition is a faulty crankshaft position sensor. It is located near the transmission and controls ignition timing. if this is bad you may have the engine stall and will not restart. I would recommend...

The new transmission rebuild should not be slipping and for the amount of money it cost to get done i would recommend having the rebuilder test the computer for codes to the transmission shift solenoids and check fluid levels and...

A diagnostic is only meaningful if there is a specific identification of a part or parts that have failed, are worn out, defective or the like. The bearings in the differential that you refer to are not visible for inspection,...

The engine compression may be low in the cylinder. If you have spark and fuel, all you need is good compression. Have the whole engine compression tested to get a general condition of the entire engine. If the compression is...

Hi. If the window came off of the track then the door panel would need to come off to see why that occurred. Most of the time the window comes off because the regulator is failing and the window bound...

Hi there. Due to the added stress and heat, an AC pump puts on your engine it is crucial that your AC fan to work properly. Since the relay has been replaced there is a strong possibility that the overheating...

While your Accord is designed to protect you against temperature extremes, it’s not airtight. That means humidity can rise in the cabin. To dehumidify the air, just follow these easy steps: Switch on the fan. Switch the air conditioning...

Hello - this message (P0335) indicates that the crankshaft position sensor is failing, causing the "cutting off" you have already noticed. It is located on the bottom of the engine/transmission interface (drivers side of the vehicle). To avoid any unnecessary...

Hey there. It's possible that the teeth on the flywheel (manual transmission) or flexplate (automatic transmission) are worn or banged up sufficiently that the starter drive on the starter won't engage properly. Moving the crankshaft as you mention may realign...

Several things could be causing this issue. The most likely would be either a dead battery, or a faulty starter. Although unlikely, the engine could also be seized. I would recommend having your vehicle inspected by a mechanic to determine...

Hi there. This problem is caused by a lack of mobility in your ignition cylinder. The bumps on your key depress a series of channels in the cylinder in the correct combination in order for it to release its locking...

It sounds as though your door latch has failed. If this happens, your door will not be able to stay closed. I would ask for assistance from a mechanic at YourMechanic, so they can come to you and repair your...

Hi there. A stuck thermostat will definitely cause your engine to overheat. When your heads warp because of this, it is necessary to take it to an engine machining shop in order for them to attempt to straighten out the...

If your car is overheating and you know that your coolant level is low, this is certainly the cause. I would first recommend to top off your cooling system with the correct amount and type of fluid. Then, start the...

The small light indicator is located on the instrument panel. This light illuminates when the headlights have been turned to the small light position.

Hi there. As you already know, replacing components without diagnoses can be expensive and time consuming without resolution. A faulty fuel injector(s) is a possibility but, the P0304 (#4 cylinder misfire) may be affecting other cylinders causing the P0300 (random...

Thank you for your inquiry. There are different options to take into consideration with diagnosing this issue. A restriction in the fuel delivery system is a likely cause. The fuel builds too slowly, enough to start the vehicle, but not...

The idle control valve on these vehicles are known to intermittently stick. The sticking would account for the intermitten stall you have encountered. Cleaning the valve may work but the best fix is to replace the valve since the sticking...

The sun roof on this car does not have any problems that stand out causing a leak on the car. The seals around the sunroof may be dried out or damaged. I recommend you have a qualified mechanic, from YourMechanic,...

While the Intelligent Key will let you open the doors and the trunk without having to press a button on the key itself, it does double as a remote entry device. To use it, you just need to take the...

The only way to determine what is broken, and who is potentially responsible or at fault, is to physically examine the engine. Speculation in the absence of a physical, on site examination is not going to help you. If you...

The speed must be taken into consideration, in order to properly diagnose a shaky steering wheel during driving. A shaking or vibrating wheel at low speed may point to a problem with tires, or with bent/broken suspension components. On the...