This may be related to a dirty or failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...
You should have the tires balanced and checked for problems with tire separation. If they are okay then have axles and suspension checked for problems like bad axle cv joints or bearings that are loose.
It sounds like you may have a couple of different issues. The problem with the shaking in the steering may be related to the steering system. What you are describing sounds like a problem with the rack and pinion gears....
A synthetic blend refers to a blend of regular oil and synthetic oil. Adding regular oil to this oil will not in any way hurt your car's engine. You won't even have to worry about getting an oil change until...
Hi there. The oil pan gasket is either a gasket of cork or rubber (silicone molded) or a spread of RTV Silicone. The oil pan gasket can be removed at home, you will just have to jack up the vehicle...
Hello, it sounds like you have a leaking injector. When you hold down the gas pedal, it puts the computer into clear flood mode and does not inject fuel into the engine. Once you clear the fuel, it starts and...
Hello - this is not a good idea for several reasons. Yes, exhaust fumes can really be pulled into the cabin by a window that is down, or through a rear hatch. In addition, the leaked exhaust, which is still...
Hey there. This can be caused by a number of things such as low coolant levels, a faulty thermostat, or a failing coolant fan switch. As you may know, the coolant fan switch helps to maintain the proper coolant temperature...
Hello there, thank you for asking about your 2004 Toyota Camry. Code P0012 relates to the camshaft position sensor which monitors the speed of the camshaft and relays this information to your car's computer, which helps to control ignition timing...
If you are continuing to get the same codes after these sensors were replaced then you more than likely have a worn out timing belt. When the belt is worn then the sensors will not read correctly. If you want...
Your low-pressure reading of 80-85 psi is a bit high. Even with ambient temperatures of 100 degrees, a reading of 50-60psi is normal. A few things can be causing that high reading. First, if the system has been charged recently,...
It all depends on what needs reprogrammed. Most dealers will have to do most programming procedures and will charge about 1.5 hours and should be expected to cost anywhere in the $175 to $250 range depending on dealer labor rate...
Hello, Since this recurring regularly the vehicle should be scanned for code. There is a good chance that the wiring to speed sensor on the transfer case has become compromised over time and the wiring harness needs to replaced. This...
The airbag light can come on for many reasons. The most common reason is for the seat belt switch failing and for the seat position switch failing. I recommend checking the engine's computer system (ECM) and checking for the airbag...
If oil and coolant have mixed or are mixing, whether in the radiator or in the crankcase, the cause of those "leaks" has to be identified and repaired first. If you were to diagnose the no start condition, even if...
