Popular questions

A shudder when turning all the way one direction or the other can be a result of low power steering fluid pressure. This can be caused by several different issues from a loose drive belt, to a bad pump, to...

Hi. This is a possibility, however, it is more likely that one of the fuel lines has a leak. The fuel pump will turn on with the key turning which would cause the gas to start pumping out when trying...

Hello there. This is more of an uncommon issue. A few different faults could cause the coil packs to fail. Most common would be not replacing all the coils at once, a wiring fault, or an ignition fault. Since you...

The ABS pump is fed power directly from a fusible link and not the 10A brake fuse. If the pump is running non-stop, this is an indication of a faulty brake pressure modulator valve unit that will need to be...

Hello - unfortunately, there is only one solution for this problem. Go to your Chrysler dealer, with proof of ownership, and your VIN number, and write them a check. The dealer is the only source of electronic keys and programming...

You will have to have the dealer reprogram the new key and transponder for it to work with your truck. The dealer will have the special scanner to do the programming. This is typical for most vehicles that have lost...

The problem may not be the hub or studs, but the rim. Look at the inside of the rim-centering hub to see if it has damage where it has not been seated properly or is unable to be seated. If...

Generally when one engine or transmission mount fails, others may fail soon after. When one mount fails, added stress is placed on the remaining mounts to hold the engine and transmission in place. Your vehicle should have 4 engine and...

In this case you will need to have the computer scanned to retrieve the codes that are stored. The codes will indicate the exact problem areas. Have the trouble codes and warning light diagnosed by a certified technician, such as...

The best way to schedule this service would be to call in to customer service and explain to them that you would like your spark plugs and all ignition coils replaced. Ignition coils to not come with the spark plug...

I think you are exactly right. The tumblers inside your ignition lock cylinder may be broken as they are usually what locks your key into each position such as accessory, on, or run. Also, if the car will not start,...

You may have a bad window switch or motor and regulator. You will need to have it tested for power to motor in the door. If it has power then replace motor.

Starting your engine is not as simple as turning the key and cranking it. There are several things that you should do before hand to ensure safety for both you and your passengers, and those around you. Here’s what you...

Hi there: Although it's very hard to tell remotely without physically inspecting your Toyota, I don't believe the oil indicator light and the thumping noise are related. It's possible that your front wheel bearings are what is causing the repeated...

In order to properly diagnose the system, the wire diagram would need to be looked at for your Chrysler. In general, the dashboard lights are powered and set to brightness from the headlight switch. Have the switch checked to see...

While the air bag system on your Accord is designed to be maintenance free, there are times when service will be necessary. These include: After Air Bag Deployment: In the event that an air bag is deployed, the air...

It sounds like you may have a vacuum leak on your car. Check all vacuum lines and make sure they are in good condition and connected. If you don't see a leak you can spray some carburetor cleaner on the...

The battery and/or the starter may be bad. The first thing that needs done is check the battery to see if it is good and will hold a charge. The starter needs over 12 volts with over 175 amps of...

Hi Diana. Thanks for contacting us today. Unfortunately, we can't attach diagrams or files through this platform. The best way to review the correct steps for completing this job would be to download or purchase a service and repair manual...

Hi there. A low coolant level can illuminate the service light and create the heating and AC problem you have described. Check the coolant level while the engine is cold and top it off as necessary. Also, look around the...

Hi Khalia. Thanks for contacting us tonight. This is a service that our mobile mechanics in your area might be able to complete for you. To request an estimate and to schedule an appointment, simply click this link and enter...

Hello. A no start condition, especially an intermittent one can be caused by a wide variety of issues. A few common causes for a no start condition are problems with the fuel or ignition systems, or perhaps an issue with...

The cooling fans work according to relays that detect temperature and cause them to turn off and on. When these relays are not working properly, this will cause them to come on all the time, not at all or intermittently....