Popular questions

I would ask for help from one of the mechanics at YourMechanic. They can come to your location and check what the problem with your fuel lines is and recommend a solution for you.

The brake pads that were installed the first time should of been installed with new or resurfaced rotors. Most noises are from uneven surfaces in the rotor and pads that do not match up causing a squeal or grind noise....

After reading all the different issues and problems you are having and the air intake problems that you are mentioning, I suggest having a mechanic do a thorough check and diagnosis of your shifting issues to see if there are...

A common failure item on your BMW is the water pump; the impeller that spins to circulate the coolant breaks off. This can be verified, without removing the pump, through an inspection of the cooling system for proper circulation. Although...

Hi there. It's quite possible that the starter has broken, however, it's also common for this type of symptom to be related to a faulty ignition relay, or starter relay. Before you decide to have the starter replaced, you might...

This is a common sign of a failing CV joint. A CV (Constant Velocity) joint is a shaft that connects the transmission to the wheels, essentially transferring the power from the drive train directly to the wheels. The CV joint...

Check inside the air filter housing and if it is not there then it is built into the mass air sensor on this model.

Hi there. It is not very common for a heat shield to come loose, which sometimes causes the noise you're describing. In most cases, it's a throttle bracket or radiator fan cover that sometimes can be the source of the...

I am making the assumption that the skip you are referring to is a misfire that you are describing. There are several factors that can cause an engine misfire. A defective distributor cap/rotor, bad spark plug, bad plug wire, internal...

Hi, what happens when you turn the key? Batteries tend to wear out around the 5 year mark so if this is still the original battery it probably needs replacing. The best way to check the battery is to hook...

In cold weather, drive belts will make this kind of squealing noise when the rubber belt material is cold and has not had a chance to warm up. Rubber is a material that is very susceptive to heat in...

If the battery is new and charged sufficiently (not all new batteries come fully charged), there should not be any problem starting the vehicle. You may want to be sure all battery cables are properly connected and that the ground...

You did not mention the engine you have in your truck, but I would suspect the engine turbo vane control is sticking when you rev the engine and will cause the engine to stay revved until the vanes go back...

With the engine fully warmed up and running in PARK, open the hood and look for the transmission dipstick. Pull it out and give it a wipe. Dip it back into the tube and pull it out, this time noting...

Hi there: It's possible that simply fixing the exhaust system will clear up the issues you're having with your vehicle. However, without knowing the exact codes triggered, the make, model and year of vehicle; and without completing an onsite inspection,...

Your issues may stem from a variety of components. Have the vehicle scanned for diagnostic troubleshooting codes. This will give you more information on any issues the computer has detected. Some will not illuminate the Check Engine Light. The vehicle...

Sometimes the seal around the sunroof sticks and if you give it a little push thats all it needs to overcome that binding, other times the switch or motor has failed but the fuse should always be checked first. Have...

The Immobilizer System Control has failed and is stuck in lock mode. I recommend either flashing the Immobilizer System Control or replacing it. If you need further assistance with your engine not starting, then seek out a professional, such as...

Hello. Thanks for writing in. When it comes to strange noises, the best thing to do is locate the exact place its coming from. The first test should be trying to replicate the noise while at idle. If you can...

This problem of a slight jerk feel is what is known as a lean tip in surge. The cause can be an indication that the engine is running lean and may be caused by dirty injectors, throttle body, air filter,...

You've said the camshaft pulley but those are the ones on the top inside. I'm assuming that you meant the crankshaft pulley. Those Lexus crankshaft pulleys often will not come off because they are kind of tight and they are...

These vehicles have a lot of issues with the wiring modules and harness connectors. The pins and connectors are really small and can loose contact really easily. The reason the MAF and fuel pump is going bad is not the...

Hello. There is likely an electrical fault on the vehicle side of the wiring harness. Blow fuses or broken wires can plague any electrical system. I recommend having an experienced technician inspect the circuitry concerning the vehicle exterior lighting system....