Skip the auto shop - Our mechanics make house calls

Q: Wire harness problem

asked by on

The wire harness has no power.

Hello. Depending on which wiring harness it is, the source of the power needs to be checked. A continuity check of the wires also needs to be done to make sure there is no break in the harness. Electrical problems need to be inspected by a qualified mechanic. Wiring diagrams, volt meters, and break out boxes are typically used for this kind of diagnosis. Depending on the extent and location of the problem, the harness may be repaired or it may need to be replaced.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I heard a loud noise from right side of my engine. My partner raised the engine, now it will not start

Hi and thanks for contacting YourMechanic. If your engine was making a loud noise and when the engine was throttled up, there is a possibility that the engine may have a connecting rod that could be knocking and getting ready...

Q: My car backfires at 50 mph.

Hi there. There is a timing problem with your engine. Check the vacuum advance to see if its advancing when the engine is at a higher rpm. Also check the spark plugs and wires for if they are burned but...

Q: Runs rough, replaced crankshaft position speed sensor

Hello, The crankshaft position circuit is the electrical circuit for the crankshaft position sensor. If the sensor has been replaced, then it may be possible that the wiring or connector that goes to the sensor is having an issue. If...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.