Q: Windshield wipers not moving but I hear the motor going. Was working before the last snow but noticed it wasn't moving Sunday nigh

It could be that there is a leak, or you may just need your refrigerant topped off. A/C is not something you can service yourself at home because it requires professional equipment. I suggest you take your vehicle to a...

If the “Traction Control System (TCS) off” Warning Indicator Light is on in the dashboard, this is an indication that the traction control system (TCS) has been disengaged. When adverse weather conditions are present such as ice, snow, or rain,...

If the transmission is not shifting gears even after a fluid service, the problem may be internal transmission failure. I do not suggest driving a vehicle with these symptoms as you risk damage to the engine. You will need to...

Hello there, thank you for asking about your 1990 Oldsmobile Toronado. You can rule out a blown fuse for both of these issues. If the fuse were blown, the circuit would not operate at all. I'm guessing from your description...

As far as the brake issue, yes, there needs to be a check to see if there is brake fluid entering into the proportional valve. If there is fluid supply to the valve but not out then the valve will...

Hello. It is possible that the problem is with the evaporator temperature sensor. If this fails, it can affect the efficiency of the AC system. Most of the time though, when the compressor continually works on this car it is...

Hey there. This sounds like a faulty alternator. Use a multi-meter to test the alternator's output voltage (https://www.yourmechanic.com/article/how-to-test-your-alternator_2). Good alternators test in the range of 13.8-14.2 volts and make sure to use the 20 volt setting, or you could receive...

A starter like any other mechanical and electrical part is subject to failing sometimes for no apparent reason. However, sometimes this is misdiagnosed as well and often times mistaken for something much more simple like a fuse or starter relay....

Fault codes may not be present if there is a hydraulic fault in the transmission. First thing to check is the transmission fluid level and condition. Low/poor fluid condition can keep the transmission from shifting properly or shift at all....