Q: While i was driving down the street my engine shut off on me.

While your car’s satellite radio should operate without any problems for the most part, there are a number of codes and messages that may be displayed on the screen. Understanding these is important. Here’s what you should know: Acquiring: This...

The Forward Collision Alert Off message can appear on your driver information center (DIC). The DIC displays this alert when the Forward Collision Alert (FCA) system is temporarily not working. When the FCA system is resolved, the alert will go...

The engines computer could be in a “limp” mode. It is a reduced power mode because of a trouble code(s) set in the computer. It does this to prevent further damage. Any type of misfire code, a major sensor, or...

Hello there. This is a common issue with your Mercury Milan. If the coolant temperature sensor (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement) reads improperly, it will set the service engine light and require replacement. This sensor is located in the thermostat housing. You can buy...

Hello! An intermittent failure of a start response can be many things - a bad ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement), starter solenoid (https://www.yourmechanic.com/services/starter-replacement), or in your case - the keys use a "raised-chip" design for security. With years of wear, the key/ignition...

Hello, thanks for writing in. This depends on a wide variety of factors that would need to be evaluated individually along with the Jeep being physically inspected and diagnosed by a professional. If you'd like to have this done, I...

Hi there: Yes, in most cases when you replace the OEM engine from any newer vehicle, you have to reprogram the ECU to communicate with the new engine. This is typically only done at a dealership these days.

Hi there. First check the oil in the engine. See if the oil is milky and not dark in color. If the oil is milky, then there is either a head gasket that is burned and putting the coolant into...

Both improper bleeding and a failed master cylinder could be the fault. Running the master cylinder dry can lead it to fail quickly. The primary seal on the master cylinder piston will tear easily. Make another attempt to bleed the...