Q: Where is the interior dome light fuse located

The Universal Garage Door Opener comes with a control panel with programmable function keys. These keys can be erased at any time. To erase the Function button codes. Hold down the two outside Function buttons. When you see the lights...

There is usually only two causes of this symptom. Inside your dash lies the evaporator for the air conditioning system. This evaporator looks like a small radiator but gets cold instead of hot. Imagine a soda can freshly opened out...

Hello. It sounds like the weather stripping on the driver's side door is worn out or missing and would need to be replaced. The soft touch pad needs to be replaced as well. I would have the door inspected by...

You need to have the fuel pressure regulator and injectors checked for leaking. The fuel pressure regulator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-pressure-regulator) is most likely leaking into the intake and causing the excessive fuel to get into the cylinders. I'd suggest getting the vehicle...

You would need to have it programmed to your VIN. Have the computer scanned to see if you have a good crank shaft signal first, before replacing the ECM. You may not need the ECM replaced; you may have a...

This may be a result of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or potentially a faulty transmission control module. A faulty transmission control module may cause a delay in acceleration or erratic shifting of gears. The transmission control module has various sensors...

Hello, thank you for writing in. The exhaust system up to the muffler is what is responsible for proper engine and emissions performance. The muffler's only job is to muffle the sound of the engine as it is amplified through...

Unfortunately, Your Mechanic does not perform engine swaps or replacements. Your best source of information for that may be internet forums that focus on the SIerra. You mat find someone on one of those forums that may have done what...

You should have the computer scanned and transmission linkage checked to see if the system has codes stored for transmission and shift linkage is not damaged and adjusted properly.