Q: Where is Crankshaft Position Sensor on 2011 VW Routan with 3.6L engine?

asked by on

Where is the Crankshaft Position Sensor on a 2011 VW Routan? Thank you!
My car has an automatic transmission.

The crankshaft position sensor is located in the right rear of the engine block. There is a protective shield that needs to be removed for access to the sensor.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Where is Crankshaft Position Sensor on 2011 VW Routan with 3.6L engine?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: 2010 Volkswagen Beetle Base 5 Cyl 2.50L Preventive Maintenance Fuel Filter- MIA or Doesn't have one Purchased a used 2010 VW b

According to the listings, there are two engine codes - BPR and BPS. Those equipped with the BPS engine have the fuel filter located under the vehicle, just ahead of the passenger side rear wheel. The BPR equipped vehicles have...

Q: CV Joint Change instead of the wheel hub assembly.

Customer wants to change the information from having a wheel hub assembly replacement changed to a CV Joint / CV Shaft replaced on the set up page.

Q: Crankshaft sensor replacement - 2014 Toyota Avalon

Hi - the crank position sensor on the V6s is located at the "nose" (passenger side) of the engine, way down low. Rather restricted access. Will require safely raising and supporting the car, and access from underneath the engine. If...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...