Q: What's the cost for front and rear break pads on 04 mazda6?

Sometimes you can use some tweezers to get the cd out when you hit the eject button. Other than that you will have to remove the radio and send it off to get them to remove the cd. A technician...

We need to start by addressing the repairs that were just made. If the noise started after the brake replacement, there is a strong possibility there is a correlation between the two. Think about the components that were just worked...

Hello there, many common faults will cause your 1995 Nissan Quest to have problems starting. You did great in replacing the battery as this is the most common fault of all time for no start conditions. There are a few...

Hello - usually power to the ignition switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-switch), engine swap or not, comes through the fuse block. So, first thing to check is the appropriate fuse for the ignition from the Jeep Owners Manual. With the engine swap, unless...

Hello, It sounds like you may have a problem with the voltage regulator. As you know, when turning on an accessory like the A/C, this puts an additional load on the motor which results in the motor needing to create...

Hi there. You might find our scheduled maintenance online tool very helpful in determining what's required at certain mileage intervals for your vehicle. Once you review the recommended service on this page (https://www.yourmechanic.com/scheduled-maintenance), you'll be able to request quotes for...

If the engine is not starting as readily as it used to, there is something wrong. There are many causes of hard starting but illustrative ones are a faulty engine coolant temperature switch (sensor), worn spark plugs, inadequate fuel delivery...

Hi there. Either the engine's timing tensioner is loose and not pressurizing up when the engine is started up or the camshaft variable timing solenoid (https://www.yourmechanic.com/services/variable-valve-timing-vvt-solenoid-replacement) is sticking when the engine oil is thick - cold. I recommend putting in...

Hi Andrew. Thanks for sending the question tonight. Changing the oil involves three basic steps, draining the old oil, removing the old oil filter, and installing new filter and oil. In some cases, if the oil filter is not correctly...