Q: service engine soon

asked by on July 14, 2017

service engine light is on , so when i got checked with scanner it showed P0014 code. So what may be the issue.?

My car has 203000 miles.
My car has an automatic transmission.

There is a TECHNICAL SERVICE BULLETIN for the problem and need to reprogram the PCM to a new level. The code is for a cam sensor signal being misread by computer and this TSB needs to be done before replacing any parts. Reference Number(s): 01-06-04-052B

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What do u mean ?

Çar engine sound like its misfiring and shakes and vibrates whole car happened twice in last 8 months

Check with the dealer to be sure the vehicle ECM has the latest software calibration from Toyota. Check for any stored trouble codes. If the problem is intermittent (and not resolved by any applicable software updates), typically that means there...

2014 town and country wouldn’t start. Battery voltage was low, so had battery tested and it failed because of bad cell. Bought rep

Your vehicle cannot cause the battery to have a bad cell on the replacement battery. Get a new replacement battery and install it and have the charging system rechecked to make sure it is not over or undercharging the battery....

2011 dodge charger rt turns over ,but wont crank

This may be related to many different possibilities, some of which may be related to a lack of spark or possibly timing issues and some of which may be related to a fuel delivery problem or a combination of both....

Crank no start

There are several possible reasons for a vehicle to crank and not start. A bad fuel pump, clogged fuel filter, faulty injectors, bad ecu, failed ignition coil, or a malfunctioning sensor. It will first be necessary to figure out if...

Alright my daughter brought her car in for oil change they said CV axles were bad needs new tires too. How to diagnose CV issue

The oil changer may have seen the CV axle boots torn open. This would allow the lube to be washed out of the joint and dirt and water to enter and damage the joint. You would not hear any noise...

Vehicles Check Engine light blinks and then stays on, runs rough like on 6 cylinders/misfiring when wet.

Hi there. Check the spark plugs and see if they are sparking. Get a code reader and check for any codes that could be stored in the computer as the check engine light is on. The code will give you...

Code p2402 evapotative emission system leak detection pump control circuit high.

In many cases a control circuit code will point out a problem with the device in the description which is the leak detection pump assembly in this case. The evaporative emissions system should be checked for any air leaks or...

New battery, no loose cable or corrosion. Car has completely no power. But will start later.

This is often times a sign of a short or a grounding issue. I would recommend checking the black negative battery cable that goes from the battery to the chassis of the car to be sure there is not a...

Related articles

P0289 OBD-II Trouble Code: Cylinder 10 Injector Circuit High
P0289 P0289 code definition The DTC P0289 code indicates that the number 10 cylinder is experiencing an above average amount of current at the fuel injector. What the P0289 code means Code P0289 means that the fuel injector circuit...
P0203 OBD-II Trouble Code: Injector Circuit Malfunction - Cylinder 3
P0203 code definition P0203 is a general OBD2 code that points to a fault in the injector circuit. Note: This...
P0345 OBD-II Trouble Code: Camshaft Position Sensor A Circuit Malfunction (Bank 2)
Trouble code P0345 means the computer has detected an incorrect voltage reading from the bank 2 camshaft position sensor.