Q: My car turns over but it has no spark and won't start

asked by on

I have replaced the camshaft sensor, crankshaft sensor, throttle position sensor, rewrapped the wire harness cause it was horrible, the codes the car was giving all went away. Timing chain is good. Still it just turns over. No start. Fuel pump is good. I'm stuck. Please help

My car has 187000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. My car turns over but it has no spark and won't start

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Bad fuel pump or another issue? 1992 GMC C1500

Hello - I agree with you that this is likely a fuel supply issue. There are several possibilities as the source of the problem fuel pump or fuel pump relay (runs, but gets hot and fails), fuel filter clogged, dirty...

Q: 1992 Ford F-350 won't start or when it does only drives 20 ft then dies

Hey there, thanks for writing in about your 1992 Ford F-350. There are a few angles to cover when checking for problems on a stalling vehicle. The fuel pressure must be correct and a clogged fuel filter can lead to...

Q: Car won't start - 1991 Ford E-350 Econoline

Crossing the positive and negative battery cables is typically pretty bad for the electronics. The battery takes the brunt of the short. It very well could have fried it. What kind of battery test was performed? Essentially you are sending...

Related articles

How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...