Q: My car has an engine check light orange in colour

asked by on September 30, 2016

some told me that i need to replace a censor oxygen

My car has 94567 miles.
My car has an automatic transmission.

Check Engine Light is on Inspection $94.99 - $114.99 Get a Quote

You will need to have the Check Engine Light diagnosed by having the computer scanned and any codes diagnosed. Be aware that O2 sensor codes may not be an O2 sensor failure but an engine running lean or too rich. I would have a local expert diagnose the Check Engine codes more thoroughly to pinpoint the problem and correct this issue properly.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the Supplemental Air Bag Warning Light mean?
The supplemental restraint system (SRS) on your Altima is pretty advanced, and is able to detect problems when they occur. If something happens that may disable all or part of the air bag system, a warning light is turned on...
How do I open and close the sunshade?
The sunshade feature allows you to block incoming light from the sun roof. The sunshade can only be operated manually. To open the sunshade, slide it open. To close the sunshade, slide it closed. The sunshade can only be closed...
Honda N WGN 660 5cc japanese frequent limp home mode
Hello, thanks for writing in about your Honda N WGN. A likely possibility related to the misfiring may be that the car's computer may have tried to recalibrate the fuel supply as a result of the faulty throttle control relay...
My car cranks but don't start. What could be the issue?
Any number of components can cause a crank but no start condition. Lack of spark - caused by a bad ignition coil or control module, as well as a crank shaft sensor could be at fault; lack of fuel due...
Loud whining noise, thick white smoke, and than car dies.
Hello. From what you describe it would appear that your vehicle may be experiencing possible mechanical or engine management issues. If these issues began after servicing the spark plugs and wires I would recommend verifying that the plugs are not...
No reverse and will not down shift.
This may be a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...
What may cause the starter to engage when shifting the shifter?
Hi there. Check the neutral safety switch and the shifter circuitry. It is possible to have a short in the wiring causing the starter to engage while shifting gears. Look for any wires that may be shorting out with the...
Timing belt failure - 2006 Chrysler Pacifica
Hi there - no, it would have been impossible for a mechanic to know a timing belt failure was imminent. Given your mileage, the timing belt has been changed at least once already. When that was done, the service center...
P0017 code 2008 Isuzu i-290
Hi There, As you know, code p0017 relates to the correlation of the camshaft and crankshaft position sensors. There are a number of things beyond replacing the sensors that also may trigger this code such as the following: -Timing chain...

Related articles

P0460 OBD-II Trouble Code: P0460 Fuel Level Sensor Circuit Malfunction
P0460 means there is a discrepancy between the fuel gauge and the actual fuel level in the tank. Which could be caused by a fuel sensor malfunction.
P0481 OBD-II Trouble Code: Cooling Fan 2 Control Circuit Malfunction
P0481 means a problem with the control circuit for cooling fan 2. Some causes are faulty cooling fan or damage to the wire connecting the cooling fan.
P0535 OBD-II Trouble Code: A/C Evaporator Temperature Sensor Circuit
P0535 means there is a problem with the A/C temperature sensor circuit, also caused by an overcharged A/C system or insufficient refrigerant levels.