Q: Makes a noise when I turn and hit bumps.

asked by on February 13, 2017

My car makes a noise on one side of the tires and a parts is loose.

My car has 186000 miles.
My car has an automatic transmission.

You should have the complete front suspension checked however the sway bar links and bushings are the most common cause of the noise when turning.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

My truck makes a noise when truck starts and smokes

You will need to give a better description of where the metal noise and smoke is coming from to help you better. You should have the belts, oil and coolant checked to see if you see any problems there. If...

Noise and pulling to right still exist after repairs

Hello. It is possible that there is a problem with the tires on your vehicle. If a tire is not perfectly round it can cause the pulling that you are experiencing as well as the noise you hear while driving....

Car won't start. Electronics work, but loud screeching noise comes from fuse/battery boxes in the trunk when turn ignition key.

Hi and thanks for contacting You Mechanic. There could be a lot of issues that could relate to this topic, however, I have narrowed it down to 4 things to check. First check the battery and make sure that the...

P0014 Code, Replaced both camshaft actuators

You will need to have the vehicle scanned with a scanner that is capable of actuating the solenoids and monitor data at the same time. The actuators when actuated at 1200 rpms should cause the rpm to change up and...

Went to take the gas cap off and it blew air out.

Excessive pressure inside the fuel cell could be caused by a clogged EVAP canister. This system is designed to filter vapors from the fuel tank for environmental reasons. If the canister is full or the purge solenoid is damaged that...

Sometimes my key gets stuck in the ignition

You have one of two different problems. Your key is worn too much and will not engage the tumblers enough to unlock the ignition lock cylinder. If the key is not worn out then your ignition lock cylinder is binding...

Car has CVT transmission, can't afford to replace, can I just replace the entire motor with a used one with different trans?

Hello. If you wanted to replace the motor and transmission, you would have other problems like the wire harnesses and ECM modules among other problems to do the swap correctly. You may be better off replacing the transmission with a...

replaced camshaft sensor on 2009 chevy malibu and now it immediately dies after startup

If you have a weak battery or a starter that turns engine too slow can cause the crank or cam signal to not be strong enough and may cause stalling. If the crank sensor is not in sync with the...

What is the average cost for a valve and piston rod replacement job. I thought it was the lifter but now they say its valve.

The cost depends on the amount of damage and is quite literally impossible to even guess at without physically removing the parts and determing exactly what parts have to be replaced. It is not just a simple matter of taking...

Related articles

The Best Used Cars to Buy If You're a Dog Trainer
If If you are a dog trainer, you expect a lot from your vehicle. You want a ride that is safe, roomy, and of course, dog friendly, since your training operation will often mean that you need to transport the...
How Car Suspension Systems Work
On the surface it appears the suspension of a car has a pretty straightforward job. If the bumps end up being...
A Buyer’s Guide to the 2012 Chevrolet Camaro
The The 2012 Chevrolet Camaro is an exciting car that says a lot about American drivers and what we want. While fuel prices are high and the economy is just barely starting to resurge and stabilize after years of recession,...